Nissan Almera Tino V10. Manual — part 734
POWER SUPPLY AND GROUND CIRCUIT CHECK FOR
MULTIFUNCTION SWITCH
=NLEL0689S02
1
CHECK FUSES
Check the fuse below.
MTBL1653
OK or NG
OK
©
GO TO 2.
NG
©
If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.
2
POWER SUPPLY CIRCUIT CHECK
1. Disconnect multifunction switch connector.
MKIB0103E
2. Check voltage between multifunction switch and ground.
MTBL1654
OK or NG
OK
©
GO TO 3.
NG
©
Check harness for open or short between multifunction switch and fuse.
LCD (LIQUID CRYSTAL DISPLAY)
Trouble Diagnoses (Cont’d)
EL-232
3
GROUND CIRCUIT CHECK
Check continuity between multifunction switch harness connector M102 terminal 1 (B) and ground.
MKIB0104E
Continuity should exist.
OK or NG
OK
©
INSPECTION END
NG
©
Check ground harness.
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
BT
HA
SC
IDX
LCD (LIQUID CRYSTAL DISPLAY)
Trouble Diagnoses (Cont’d)
EL-233
VEHICLE SPEED SIGNAL CHECK
=NLEL0689S03
1
HARNESS CHECK
1. Disconnect display unit connector and combination meter.
2. Check the following.
–
Continuity between display unit connector M96 terminal 11 (L/B) and combination meter connector M84 terminal 10
(L/B).
YEL404E
Continuity should exist.
–
Continuity between display unit connector M96 terminal 11 (L/B) and ground.
Continuity should not exist.
OK or NG
OK
©
GO TO 2.
NG
©
Replace harness or connector.
LCD (LIQUID CRYSTAL DISPLAY)
Trouble Diagnoses (Cont’d)
EL-234
2
VEHICLE SPEED SIGNAL CHECK
Connect combination meter connector and display unit connector.
With CONSULT-II
1. Lift up drive wheels.
2. Start engine and drive vehicle at more than 20 km/h (12 MPH).
3. Check signal between display unit connector M96 terminal 11 (L/B) and ground when rotating wheels with engine at
idle. (Use “SIMPLE OSCILLOSCOPE” in “SUB MODE” with CONSULT-II.)
YEL573E
11 - Ground: “Terminal and Reference Value for Display” EL-221
Without CONSULT-II
1. Lift up drive wheels.
2. Start engine and drive vehicle at more than 20 km/h (12 MPH).
3. Check voltage between display unit connector M96 terminal 11 (L/B) and ground when rotating wheels with engine at
idle.
MKIB0208E
Voltage: Approximately 0 - 5V
OK or NG
OK
©
Replace display unit.
NG
©
Check combination meter system. Refer to EL-107, “Combination Meter Self-Diagnoses”.
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
BT
HA
SC
IDX
LCD (LIQUID CRYSTAL DISPLAY)
Trouble Diagnoses (Cont’d)
EL-235
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст