Nissan Almera Tino V10. Manual — part 733
DISPLAY DIAGNOSIS
=NLEL0553S02
Use this mode to check the display color brightness and setting.
The display unit must be replaced if the color brightness and shad-
ing are unusual.
MKIB0134E
CAUTION:
When Display Color Spectrum Bar screen is completed after
“BACK” switch is pressed, the screen color changes once.
This is normal.
LCD (LIQUID CRYSTAL DISPLAY)
Confirmation/Adjustment Mode (Cont’d)
EL-228
MKIB0136E
VEHICLE SIGNALS
=NLEL0553S03
I
In this mode, following input signals to the display unit can be
checked on the display.
Diagnosis item
Display
Condition
Remarks
Vehicle speed
ON
Vehicle speed is greater than 0 km/h (0
MPH).
Changes in indication may be delayed by
approx. 1.5 seconds. This is normal.
OFF
Vehicle speed is 0 km /h (0 MPH).
–
Ignition switch is in “ACC” position.
Light
ON
Lighting switch is 1st or 2nd position.
—
OFF
Lighting switch is “OFF” position.
IGN
ON
Ignition switch is in “ON” position.
—
OFF
Ignition switch is in “ACC” or “OFF” position.
I
If vehicle speed is NG, refer to EL-234.
I
If light is NG, refer to EL-236.
I
If IGN is NG, refer to EL-236.
MKIB0148E
SERVICE
NLEL0553S04
I
In this mode, service schedule can be set on this display.
NOTE:
I
To set service schedule, change journey distance.
I
When the indicator of “Service Information Display” is set
green, the color of the journey distance marker will be red. And
automatically service information screen will be displayed
when journey distance is reached on service schedule.
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
BT
HA
SC
IDX
LCD (LIQUID CRYSTAL DISPLAY)
Confirmation/Adjustment Mode (Cont’d)
EL-229
Trouble Diagnoses
=NLEL0689
POWER SUPPLY AND GROUND CIRCUIT CHECK FOR
DISPLAY UNIT
NLEL0689S01
1
CHECK FUSE
Check that the following fuses in display are blown.
MTBL1650
OK or NG
OK
©
GO TO 2.
NG
©
If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.
2
POWER SUPPLY CIRCUIT CHECK
1. Disconnect display connector.
MKIB0101E
2. Check voltage between display unit connector and ground.
MTBL1651
OK or NG
OK
©
GO TO 3.
NG
©
Check harness for open or short between display and fuse.
LCD (LIQUID CRYSTAL DISPLAY)
Trouble Diagnoses
EL-230
3
GROUND CIRCUIT CHECK
Check continuity between display unit and ground.
MKIB0102E
MTBL1652
OK or NG
OK
©
INSPECTION END
NG
©
Check ground harness.
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
BT
HA
SC
IDX
LCD (LIQUID CRYSTAL DISPLAY)
Trouble Diagnoses (Cont’d)
EL-231
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст