Nissan Almera Tino V10. Manual — part 909
MT-14
[RS6F51R]
AIR BREATHER HOSE
AIR BREATHER HOSE
PFP:31098
Removal and Installation
ECS0095S
Refer to the figure for air breather hose removal and installation information.
CAUTION:
●
Make sure there are no pinched or restricted areas on the air breather hose caused by bending or
winding when installing it.
●
Be sure to insert hose into the transaxle tube until overlap area reaches the spool.
SCIA0747E
TRANSAXLE ASSEMBLY
MT-15
[RS6F51R]
D
E
F
G
H
I
J
K
L
M
A
B
MT
TRANSAXLE ASSEMBLY
PFP:32010
Removal and Installation
ECS0095T
REMOVAL
1.
Remove battery and its bracket.
2.
Remove fuse box from battery bracket.
3.
Remove air cleaner box with mass air flow sensor.
4.
Remove air breather hose and vacuum pump hose.
5.
Remove fuel filter bracket.
6.
Remove clutch operating cylinder.
CAUTION:
Do not depress clutch pedal during removal procedure.
7.
Disconnect control cable from transaxle.
8.
Drain gear oil from transaxle.
9.
Disconnect neutral switch and back-up lamp switch harness connectors.
10. Remove starter motor.
11. Remove crankshaft position sensor (POS) from transaxle.
12. Remove exhaust front tube and the drive shaft.
13. Place a jack onto the transaxle.
CAUTION:
When setting jack, be careful not to bring it into contact with the switch.
14. Remove center member, engine insulator and engine mount bracket.
15. Support engine by placing a jack under oil pan.
16. Remove bolts securing transaxle to engine.
MCIA0121E
MT-16
[RS6F51R]
TRANSAXLE ASSEMBLY
17. Remove transaxle from vehicle.
INSTALLATION
Paying attention to the following items, install in the reverse order of removal.
●
When installing the transaxle to the engine, tighten to the specified torque.
CAUTION:
When installing transaxle, be careful not to bring transaxle input shaft into contact with the clutch
cover.
●
After installation, check oil level, and look for leaks and loose
mechanisms.
MTD0062D
Bolt No.
1
2
3
4
5
6
Quantity
2
2
1
1
3
1
“
” mm (in)
55
(2.17)
70
(2.76)
120
(4.72)
45
(1.77)
40
(1.57)
35
(1.38)
Tightening torque
N·m (kg-m, ft-lb)
39 - 49
(4.0 - 5.0, 29 - 36)
42 - 52
(4.2 - 5.3, 30 - 38)
MCIA0014E
TRANSAXLE ASSEMBLY
MT-17
[RS6F51R]
D
E
F
G
H
I
J
K
L
M
A
B
MT
Component Parts
ECS0095U
CASE AND HOUSING COMPONENTS
1.
Clutch housing
2.
Input shaft oil seal
3.
Oil channel
4.
Magnet
5.
Differential oil seal
6.
Ball pin
7.
Washer
8.
Transaxle case
9.
Welch plug
10. Bore plug
11. Differential oil seal
12. Park/Neutral position switch
13. Oil gutter
14. Back-up lamp switch
15. Air breather tube
16. Baffle plate
17. Filler plug
18. Gasket
19. Drain plug
20. Gasket
MCIA0122E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст