Nissan Almera Tino V10. Manual — part 177
AT-432
[ALL]
DISASSEMBLY
37. Remove needle bearing from rear internal gear.
●
Check needle bearing for damage or wear.
38. Remove forward clutch assembly from transmission case.
39. Remove thrust washer from transmission case.
40. Remove output shaft assembly according to the following proce-
dures.
a.
Remove side cover bolts.
b.
Remove side cover by lightly tapping it with a soft hammer.
●
Be careful not to drop output shaft assembly. It might
come out when removing side cover.
SAT056D
SAT272E
AAT215A
SAT059D
SAT434D
DISASSEMBLY
AT-433
[ALL]
D
E
F
G
H
I
J
K
L
M
A
B
AT
c.
Remove adjusting shim.
d.
Remove output shaft assembly.
●
If output shaft assembly came off with side cover, tap cover
with a soft hammer to separate.
e.
Remove needle bearing.
41. Disassemble reduction pinion gear according to the following
procedures.
a.
Set manual shaft to position “P” to fix idler gear.
b.
Unlock idler gear lock nut using a pin punch.
SAT440D
SAT439D
SAT435D
SAT453D
SAT060D
AT-434
[ALL]
DISASSEMBLY
c.
Remove idler gear lock nut.
●
Do not reuse idler gear lock nut.
d.
Remove idler gear with puller.
e.
Remove reduction pinion gear.
f.
Remove adjusting shim from reduction pinion gear.
42. Remove return spring from parking shaft with screwdriver.
43. Draw out parking shaft and remove parking pawl from transmis-
sion case.
SAT061D
AAT480
SAT310G
SAT064D
SAT065D
DISASSEMBLY
AT-435
[ALL]
D
E
F
G
H
I
J
K
L
M
A
B
AT
44. Check parking pawl and shaft for damage or wear.
45. Remove parking actuator support from transmission case.
●
Check parking actuator support for damage or wear.
46. Remove revolution sensor from transmission case.
SAT066D
SAT311G
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст