Nissan Almera Tino V10. Manual — part 703
Check items
Display
Remarks
F)
PCB code
MKIB0006E
This information is not used for service. Please skip this
step.
G)
Meter/gauge test
(Sweeping movement)
MKIB0007E
Tachometer, speedometer, fuel level gauge and water
temperature gauge have sweeping movement test.
(The meter/gauges operate MIN.
,
MAX., MAX.
,
MIN.
for 2 times)
The odo trip meter segment flashes during the sweep
movement.
H)
Error 1
(Bit 0 - Bit 3)
MKIB0008E
The segment of each bit displays “0”, meaning no failure.
If the bit(s) displays figures other than “0”, the item of the
bit has failed.
For details, refer to “Failure chart for Error 1 and Error E”
below.
I)
Error E
(Bit 4 - Bit 7)
MKIB0009E
J)
Fuel warning lamp test
MKIB0010E
All warning lamps and indicator lamps (except security
indicator) are on and odo trip meter segment “FUEL”
flashes.
METERS AND GAUGES
Combination Meter Self-Diagnosis (Cont’d)
EL-108
Failure Chart for “Error 1” and “Error E”
=NLEL0447S0101
Bit
Detectable items
Description of the failure
Displayed figure on the
bit
Failure
No failure
0
Speedometer input sig-
nal
No input signal
When no signal is detected for 30 minutes continuously with
the ignition ON, it should be judged as signal failure.
(If input signal is detected later, then the judgement will be can-
celed immediately.)
1
0
Unusual input signal
When any signal of frequency which would not exist in normal
conditions is detected, it should be judged as signal failure.
2
1
Tachometer input signal
No input signal
When no signal is detected for 30 minutes continuously with
the ignition ON, it should be judged as signal failure.
(If input signal is detected later, then the judgement will be can-
celed immediately.)
1
0
Unusual input signal
When any signal of frequency which would not exist in normal
conditions is detected, it should be judged as signal failure.
2
2
Fuel level input signal
Short circuit
When short circuit of the signal line is detected for 5 seconds
or more, it should be judged as short-circuit failure.
1
0
Open circuit
When open circuit of the signal line is detected for 5 seconds
or more, it should be judged as open-circuit failure.
2
3
Water temperature input
signal
Short circuit
When short circuit of the signal line is detected for 5 seconds
or more, it should be judged as short-circuit failure.
1
0
Open circuit
When open circuit of the signal line is detected for 5 seconds
or more, it should be judged as open-circuit failure.
2
4
—
—
0
0
5
Reset buttons
Short circuit for reset buttons
When the short circuit is continuously detected for 5 minutes or
more, it should be judged as short-circuit failure.
1
0
6
—
—
0
0
7
—
—
0
0
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
BT
HA
SC
IDX
METERS AND GAUGES
Combination Meter Self-Diagnosis (Cont’d)
EL-109
Trouble Diagnoses
NLEL0448
PRELIMINARY CHECK
NLEL0448S01
SEL494Y
*1: Combination Meter Self-Diagnosis
*2: POWER SUPPLY AND GROUND
CIRCUIT CHECK (EL-111)
*3: Symptom Chart (EL-110)
SYMPTOM CHART
NLEL0448S02
Symptom
Possible causes
Repair order
One of speedometer/
tachometer/fuel gauge/
water temp. gauge is mal-
functioning.
1. Sensor signal
- Vehicle speed signal
- Engine speed signal
- Fuel gauge
- Water temp. gauge
2. Unified meter control unit
1. Check the sensor for malfunctioning meter/gauge.
INSPECTION/VEHICLE SPEED SIGNAL (WITH ESP
SYSTEM) (Refer to EL-112.)
INSPECTION/VEHICLE SPEED SIGNAL (WITHOUT
ESP SYSTEM) (Refer to EL-112.)
INSPECTION/ENGINE REVOLUTION SIGNAL
(Refer to EL-112.)
INSPECTION/FUEL LEVEL SENSOR UNIT (Refer to
EL-113.)
INSPECTION/WATER TEMPERATURE SIGNAL
(Refer to EL-114.)
2. Replace unified meter control unit assembly.
Multiple meter/gauge are
malfunctioning. (except
odo/trip meter)
Unified meter control unit
Before starting trouble diagnoses below, perform PRELIMINARY
CHECK, EL-110.
METERS AND GAUGES
Trouble Diagnoses
EL-110
YEL330E
POWER SUPPLY AND GROUND CIRCUIT CHECK
=NLEL0448S03
Power Supply Circuit Check
NLEL0448S0301
Terminals
Ignition switch position
(+)
(−)
OFF
ACC
ON
3
Ground
Battery
voltage
Battery
voltage
Battery
voltage
2
Ground
0V
0V
Battery
voltage
5
Ground
0V
Battery
voltage
Battery
voltage
If NG, check the following.
I
10A fuse [No. 12, located in fuse block (J/B)]
I
10A fuse [No. 30, located in fuse block (J/B)]
I
10A fuse [No. 1, located in fuse block (J/B)]
I
Harness for open or short between fuse and combination
meter
YEL331E
Ground Circuit Check
NLEL0448S0302
Terminals
Continuity
4 - Ground
Yes
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
BT
HA
SC
IDX
METERS AND GAUGES
Trouble Diagnoses (Cont’d)
EL-111
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст