Nissan Murano Z51. Manual — part 936
INT-14
< REMOVAL AND INSTALLATION >
DOOR FINISHER
7.
Remove armrest finisher (1) with remover tool (A).
8.
Remove the bolt (B) located behind the armrest finisher with tool
(A).
9.
Remove step lamp (1) with remover tool (A) and then disconnect
the harness connector. Refer to
INL-127, "Removal and Installa-
10. Remove seat memory switch finisher (1) and rear heated seat (LH/RH) switch finisher (2) with remover
tool (A) and then disconnect the harness connectors. (With sunroof)
: Pawl
JMJIA1355ZZ
JMJIA1356ZZ
: Pawl
JMJIA1357ZZ
: Pawl
JMJIA1358ZZ
DOOR FINISHER
INT-15
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
11. Insert remover tool (A) between door finisher and door panel to
disengage door finisher mounting clips, starting from the bottom
and working to the top.
12. Pull up front door finisher and pull out.
13. Disconnect lock knob cable (1) and inside handle cable (2) from
front door inside handle (3).
14. Remove front door finisher.
15. Remove the inside handle after removing front door finisher. Refer to
.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
When installing door finisher, check that clips are securely fitted in panel holes on body, and then
press them in.
REAR DOOR FINISHER
: Clip
JMJIA1362ZZ
JMJIA1359ZZ
INT-16
< REMOVAL AND INSTALLATION >
DOOR FINISHER
REAR DOOR FINISHER : Exploded View
INFOID:0000000005513289
REAR DOOR FINISHER : Removal and Installation
INFOID:0000000005513290
CAUTION:
Wrap the tip of flat-bladed screwdriver with a cloth before remove.
REMOVAL
1.
Fully open rear door window.
2.
Remove inside handle escutcheon (1) with remover tool (A).
1.
Inside handle escutcheon
2.
Step lamp
3.
Power window switch finisher
4.
Rear door finisher
5.
Rear door inside handle
6.
Rear heated seat switch finisher
7.
Rear door panel
8.
Rear door inside seal
9.
Armrest finisher
10. Power window switch
: Clip
: Pawl
JMJIA1349ZZ
: Pawl
JMJIA1350ZZ
DOOR FINISHER
INT-17
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
3.
Remove bolt (B) located behind the inside handle escutcheon
with tool (A).
4.
Pull up power window switch finisher (1) with remover tool (A) to
disengage the pawls.
5.
Disconnect power window switch connector, and then remove power window switch finisher.
6.
Remove bolt (B) located behind power window switch finisher
with tool (A).
7.
Remove armrest finisher (1) with remover tool (A).
JMJIA1351ZZ
: Pawl
JMJIA1361ZZ
JMJIA1354ZZ
: Pawl
JMJIA1355ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст