Nissan Titan A60. Manual — part 978
HEATER CORE
VTL-15
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
HEATER CORE
Removal and Installation
INFOID:0000000006161797
Heater and Cooling Unit Assembly
REMOVAL
1. Remove the heater and cooling unit assembly. Refer to
VTL-13, "Removal and Installation"
.
LJIA0138E
1.
Heater core cover
2.
Heater core pipe bracket
3.
Heater core
4.
Upper bracket
5.
Upper heater and cooling unit case
6.
A/C evaporator
7.
Lower heater and cooling unit case
8.
Blower motor
9.
Variable blower control or front blow-
er motor resistor if equipped
VTL-16
< REMOVAL AND INSTALLATION >
HEATER CORE
2. Remove the four screws and remove the upper bracket.
3. Remove the four screws and remove the heater core cover.
4. Remove the heater core pipe bracket.
5. Remove the heater core.
NOTE:
If the in-cabin microfilters are contaminated from coolant leaking
from the heater core, replace the in-cabin microfilters with new
ones before installing the new heater core.
INSTALLATION
Installation is in the reverse order of removal.
LJIA0134E
DEFROSTER DOOR MOTOR
VTL-17
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
DEFROSTER DOOR MOTOR
Removal and Installation
INFOID:0000000006161798
Defroster Door Motor - Heater and Cooling Unit Assembly
REMOVAL
1. Remove the lower knee protector. Refer to
.
2. Remove the accelerator pedal. Refer to
ACC-3, "Removal and Installation"
.
3. Remove the BCM. Refer to
BCS-53, "Removal and Installation"
.
4. Remove the Bose speaker audio amplifier, if equipped. Refer to
AV-335, "Removal and Installation"
5. Disconnect the defroster door motor electrical connector.
6. Remove the three screws and remove the defroster door motor.
INSTALLATION
Installation is in the reverse order of removal.
LJIA0139E
1.
Heater and cooling unit assembly
2.
Intake door motor
3.
Air mix door motor (driver)
4.
Variable blower control or front blower
motor resistor if equipped
5.
Air mix door motor (passenger)
6.
Mode door motor
7.
Defroster door motor
VTL-18
< REMOVAL AND INSTALLATION >
INTAKE DOOR MOTOR
INTAKE DOOR MOTOR
Removal and Installation
INFOID:0000000006161799
Intake Door Motor - Heater and Cooling Unit Assembly
REMOVAL
1. Remove the heater and cooling unit assembly. Refer to
VTL-13, "Removal and Installation"
.
2. Remove the steering member from the heater and cooling unit assembly.
3. Disconnect the intake door motor electrical connector.
4. Remove the three screws and remove the intake door motor.
INSTALLATION
Installation is in the reverse order of removal.
LJIA0139E
1.
Heater and cooling unit assembly
2.
Intake door motor
3.
Air mix door motor (driver)
4.
Variable blower control or front blower
motor resistor if equipped
5.
Air mix door motor (passenger)
6.
Mode door motor
7.
Defroster door motor
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст