Nissan Titan A60. Manual — part 979
MODE DOOR MOTOR
VTL-19
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
MODE DOOR MOTOR
Removal and Installation
INFOID:0000000006161800
Mode Door Motor - Heater and Cooling Unit Assembly
REMOVAL
1. Remove the center console lower cover LH. Refer to
2. Disconnect the mode door motor electrical connector.
3. Remove the two screws and remove the mode door motor.
INSTALLATION
Installation is in the reverse order of removal.
LJIA0139E
1.
Heater and cooling unit assembly
2.
Intake door motor
3.
Air mix door motor (driver)
4.
Variable blower control or front blower
motor resistor if equipped
5.
Air mix door motor (passenger)
6.
Mode door motor
7.
Defroster door motor
VTL-20
< REMOVAL AND INSTALLATION >
AIR MIX DOOR MOTOR
AIR MIX DOOR MOTOR
Removal and Installation
INFOID:0000000006161801
Air Mix Door Motors - Heater and Cooling Unit Assembly
AIR MIX DOOR MOTOR (DRIVER)
Removal
1. Remove the heater and cooling unit assembly. Refer to
VTL-13, "Removal and Installation"
.
2. Remove the steering member from the heater and cooling unit assembly.
3. Disconnect the air mix door motor electrical connector.
4. Remove the three screws and remove the air mix door motor.
Installation
Installation is in the reverse order of removal.
AIR MIX DOOR MOTOR (PASSENGER)
Removal
LJIA0139E
1.
Heater and cooling unit assembly
2.
Intake door motor
3.
Air mix door motor (driver)
4.
Variable blower control or front blower
motor resistor if equipped
5.
Air mix door motor (passenger)
6.
Mode door motor
7.
Defroster door motor
AIR MIX DOOR MOTOR
VTL-21
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
1. Remove the center console lower cover LH. Refer to
2. Disconnect the air mix door motor electrical connector.
3. Remove the three screws and remove the air mix door motor.
Installation
Installation is in the reverse order of removal.
VTL-22
< REMOVAL AND INSTALLATION >
VARIABLE BLOWER CONTROL
VARIABLE BLOWER CONTROL
Removal and Installation
INFOID:0000000006161802
Variable Blower Control - Heater and Cooling Unit Assembly
REMOVAL
1. Remove the glove box assembly. Refer to
IP-16, "Removal and Installation"
2. Disconnect the variable blower control electrical connector.
3. Remove the two screws and remove the variable blower control.
INSTALLATION
Installation is in the reverse order of removal.
LJIA0139E
1.
Heater and cooling unit assembly
2.
Intake door motor
3.
Air mix door motor (driver)
4.
Variable blower control or front blower
motor resistor if equipped
5.
Air mix door motor (passenger)
6.
Mode door motor
7.
Defroster door motor
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст