Nissan Titan A60. Manual — part 145
REAR DISC BRAKE
BR-7
< BASIC INSPECTION >
C
D
E
G
H
I
J
K
L
M
A
B
BR
N
O
P
REAR DISC BRAKE
BRAKE PAD
BRAKE PAD : Inspection
INFOID:0000000006163269
PAD WEAR
Check pad thickness from the inspection hole on cylinder body.
Check using a scale if necessary.
DISC ROTOR
DISC ROTOR : Inspection
INFOID:0000000006163270
VISUAL
Check surface of disc rotor for uneven wear, cracks, and serious damage. Replace as necessary.
RUNOUT
1. Attach disc rotor to wheel hub using wheel nuts (at two or more
positions).
2. Inspect runout using dial gauge placed at 10 mm (0.39 in) inside
disc edge.
NOTE:
Before measuring, make sure that wheel bearing axial end play
is within the specification. Refer to
.
3. When runout exceeds limit value, displace mounting positions of disc rotor by one hole. And then find a
position of the minimum value for runout.
4. If runout is outside the specified value after performing the above operation, turn disc rotor using Tool.
THICKNESS
Check the thickness of the disc rotor using a micrometer. Replace
disc rotor if the thickness is under the wear limit.
Standard thickness
: Refer to
.
Repair limit thickness
: Refer to
.
ALFIA0150ZZ
Runout limit
: Refer to
(with it attached to the vehicle)
Tool number
: 38-PFM90.5 ( — )
ALFIA0151ZZ
Standard thickness
: Refer to
.
Repair limit thickness
: Refer to
.
Maximum uneven wear
(Measured at 8 positions)
: Refer to
.
SFIA2284E
BR-8
< BASIC INSPECTION >
BRAKE BOOSTER
BRAKE BOOSTER
Inspection
INFOID:0000000006163271
OPERATION
With engine stopped, change vacuum to atmospheric pressure by
depressing brake pedal several times. Then with brake pedal fully
depressed, start engine and when vacuum pressure reaches the
standard, make sure that clearance between brake pedal and floor
panel decreases.
AIR TIGHT
• Run engine at idle for approximately 1 minute, and stop it after
applying vacuum to booster. Depress brake pedal normally to
change vacuum to atmospheric pressure. Make sure that distance
at intervals of 5 seconds between brake pedal and floor panel
gradually increases.
• Depress brake pedal while engine is running, and stop engine with pedal depressed. The pedal stroke
should not change after holding pedal down for 30 seconds.
BRA0037D
SBR365AA
VACUUM LINES
BR-9
< BASIC INSPECTION >
C
D
E
G
H
I
J
K
L
M
A
B
BR
N
O
P
VACUUM LINES
Inspection
INFOID:0000000006163272
VISUAL INSPECTION
Check for improper assembly, damage and deterioration. Replace as necessary.
CHECK VALVE INSPECTION
Airtightness Inspection
Use a suitable vacuum pump to check. Connect to brake booster
side of check valve.
LFIA0217E
Check valve specification
: Refer to
BR-10
< BASIC INSPECTION >
BRAKE MASTER CYLINDER
BRAKE MASTER CYLINDER
On Board Inspection
INFOID:0000000006163273
LEAK INSPECTION
Check for leaks at master cylinder to brake booster attachment point, reservoir tank, and brake tube connec-
tions.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст