Nissan Pathfinder (2008 year). Manual — part 23
AV-24
< ECU DIAGNOSIS >
[BASE AUDIO]
AUDIO UNIT
ALNIA0569GB
AV
AUDIO UNIT
AV-25
< ECU DIAGNOSIS >
[BASE AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
ALNIA0570GB
AV-26
< ECU DIAGNOSIS >
[BASE AUDIO]
AUDIO UNIT
ALNIA0571GB
AV
AUDIO UNIT
AV-27
< ECU DIAGNOSIS >
[BASE AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
ALNIA0572GB
AV-28
< SYMPTOM DIAGNOSIS >
[BASE AUDIO]
AUDIO SYSTEM
SYMPTOM DIAGNOSIS
AUDIO SYSTEM
AUDIO UNIT
AUDIO UNIT : Symptom Table
INFOID:0000000001499946
Symptom
Possible cause
Reference page
Inoperative
• Audio unit power circuit
• Audio unit
•
•
All speakers do not sound
• Audio unit power circuit
• Audio unit
•
•
One or several speakers do not sound
• Front door speaker
• Front tweeter
• Rear door speaker
•
•
•
AV
NORMAL OPERATING CONDITION
AV-29
< SYMPTOM DIAGNOSIS >
[BASE AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
NORMAL OPERATING CONDITION
Description
INFOID:0000000001499949
The majority of the audio concerns are the result of outside causes (bad CD, electromagnetic interference,
etc.).
NOISE
The following noise results from variations in field strength, such as fading noise and multi-path noise, or
external noise from trains and other sources. It is not a malfunction.
• Fading noise: This noise occurs because of variations in the field strength in a narrow range due to moun-
tains or buildings blocking the signal.
• Multi-path noise: This noise results from the waves sent directly from the broadcast station arriving at the
antenna at a different time from the waves which reflect off mountains or buildings.
The vehicle itself can be a source of noise if noise prevention parts or electrical equipment is malfunctioning.
Check if noise is caused and/or changed by engine speed, ignition switch turned to each position, and opera-
tion of each piece of electrical equipment, and determine the cause.
NOTE:
The source of the noise can be found easily by listening to the noise while removing the fuses of electrical
components, one by one.
Type of Noise and Possible Cause
Occurrence condition
Possible cause
Occurs only when engine is ON.
A continuous growling noise occurs. The speed of
the noise varies with changes in the engine speed.
• Ignition components
The occurrence of the noise is linked with the operation of the fuel pump.
• Fuel pump condenser
Noise only occurs when various
electrical components are oper-
ating.
A cracking or snapping sound occurs with the op-
eration of various switches.
• Relay malfunction, audio unit malfunction
The noise occurs when various motors are operat-
ing.
• Motor case ground
• Motor
The noise occurs constantly, not just under certain conditions.
• Rear defogger coil malfunction
• Open circuit in printed heater
• Poor ground of antenna feeder line
A cracking or snapping sound occurs while the vehicle is being driven, especially when
it is vibrating excessively.
• Ground wire of body parts
• Ground due to improper part installation
• Wiring connections or a short circuit
AV-30
< PRECAUTION >
[BASE AUDIO]
PRECAUTIONS
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:0000000001731048
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the “SRS AIRBAG” and “SEAT BELT” of this
Service Manual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the “SRS AIRBAG”.
• Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har-
ness connectors.
AV
AUDIO UNIT
AV-31
< ON-VEHICLE REPAIR >
[BASE AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
ON-VEHICLE REPAIR
AUDIO UNIT
Removal and Installation
INFOID:0000000001315974
Removal and Installation
REMOVAL
1.
Remove the cluster lid C. Refer to
IP-10, "Removal and Installation"
2.
Remove the audio control unit screws, using power tool.
3.
Remove the audio control unit and disconnect audio control unit connectors.
4.
Remove the audio control unit brackets screws and remove the audio control unit brackets.
1.
Audio control unit
2.
Audio control unit brackets (LH) and
(RH)
3.
Cluster lid C
ALNIA0341ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст