Nissan Pathfinder (2008 year). Manual — part 568
SRC-26
< COMPONENT DIAGNOSIS >
B1129 – B1132 SIDE AIRBAG MODULE RH
B1129 – B1132 SIDE AIRBAG MODULE RH
Description
INFOID:0000000001277736
DTC B1129 – B1132 FRONT RH SIDE AIR BAG MODULE
The front RH side air bag module is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor
unit will monitor for opens and shorts in detected lines to the front RH side air bag module.
PART LOCATION
SRC-7, "SRS Component Parts Location"
DTC Logic
INFOID:0000000001277737
DTC DETECTION LOGIC
With CONSULT-lll
Without CONSULT-lll
DTC CONFIRMATION PROCEDURE (With CONSULT-lll)
1.
IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 2
2.
CONSULT-III
Select "DIAG MODE".
>> GO TO 3
3.
DTC
If DTC is detected. Refer to
SRC-27, "Diagnosis Procedure (Component diagnosis)"
.
>> END
CONSULT-III name
DTC
DTC detecting condition
Repair order
SIDE MODULE RH
[OPEN]
B1129
Front RH side air bag module circuit is
open.
1.
Visually check the wiring harness connection.
2.
Replace the harness if it has visible damage.
3.
Replace the front RH seat back assembly.
4.
Replace the air bag diagnosis sensor unit.
5.
Replace the related harness.
SIDE MODULE RH
[VB-SHORT]
B1130
Front RH side air bag module circuit is
shorted to a power supply circuit.
SIDE MODULE RH
[GND-SHORT]
B1131
Front RH side air bag module circuit is
shorted to ground.
SIDE MODULE RH
[SHORT]
B1132
Front RH side air bag module circuits are
shorted to each other.
WHIA0264E
B1129 – B1132 SIDE AIRBAG MODULE RH
SRC-27
< COMPONENT DIAGNOSIS >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
DTC CONFIRMATION PROCEDURE (Without CONSULT-lll)
NOTE:
SRS will not enter diagnosis mode if no malfunction is detected in user mode.
1.
IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 2
2.
IGNITION SWITCH
After air bag warning lamp lights for 7 seconds, turn ignition switch OFF within 1 second.
>> GO TO 3
3.
WAIT TIME
Wait more than 3 seconds.
>> GO TO 4
4.
REPEAT STEPS
Repeat steps 1 to 3 twice.
>> GO TO 5
5.
IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 6
6.
DIAGNOSTIC MODE
SRS system is now in diagnostic mode and AIR BAG warning lamp flashes. Refer to
.
>> END
Diagnosis Procedure (Component diagnosis)
INFOID:0000000001277738
Recheck SRS after each replacement.
1.
HARNESS CONNECTOR
Is there any visible damage to the connector?
YES or NO
YES
>> Replace the harness.
NO
>> GO TO 2
2.
WIRING HARNESS
Is there any visible damage to the harness?
YES or NO
YES
>> Replace the harness.
NO
>> GO TO 3
3.
FRONT RH SIDE AIR BAG MODULE
Replace the front RH seat back assembly. Refer to
SE-29, "Removal and Installation"
.
>> GO TO 4
4.
AIR BAG DIAGNOSIS SENSOR UNIT
SRC-28
< COMPONENT DIAGNOSIS >
B1129 – B1132 SIDE AIRBAG MODULE RH
Replace the air bag diagnosis sensor unit. Refer to
SR-15, "Removal and Installation"
>> GO TO 5
5.
RELATED HARNESS
Replace the related harness.
>> END
B1198 – B1201 SIDE CURTAIN AIR BAG MODULE LH (FRONT)
SRC-29
< COMPONENT DIAGNOSIS >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
B1198 – B1201 SIDE CURTAIN AIR BAG MODULE LH (FRONT)
Description
INFOID:0000000001277789
DTC B1198 – B1201 LH SIDE CURTAIN AIR BAG MODULE (FRONT)
The LH side curtain air bag module (front) is wired to the air bag diagnosis sensor unit. The air bag diagnosis
sensor unit will monitor for opens and shorts in detected lines to the LH side curtain air bag module (front).
PART LOCATION
SRC-7, "SRS Component Parts Location"
DTC Logic
INFOID:0000000001277790
DTC DETECTION LOGIC
With CONSULT-lll
Without CONSULT-lll
DTC CONFIRMATION PROCEDURE (With CONSULT-lll)
1.
IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 2
2.
CONSULT-III
Select "DIAG MODE".
>> GO TO 3
3.
DTC
If DTC is detected. Refer to
SRC-30, "Diagnosis Procedure (Component diagnosis)"
.
>> END
CONSULT-III name
DTC
DTC detecting condition
Repair order
FR CURTN MODULE LH
[OPEN]
B1198
LH side curtain air bag module (front) cir-
cuit is open.
1.
Visually check the wiring harness connection.
2.
Replace the harness if it has visible damage.
3.
Replace the LH side curtain air bag module.
4.
Replace the air bag diagnosis sensor unit.
5.
Replace the related harness.
FR CURTN MODULE LH
[VB-SHORT]
B1199
LH side curtain air bag module (front) cir-
cuit is shorted to a power supply circuit.
FR CURTN MODULE LH
[GND-SHORT]
B1200
LH side curtain air bag module (front) cir-
cuit is shorted to ground.
FR CURTN MODULE LH
[SHORT]
B1201
LH side curtain air bag module (front) cir-
cuits are shorted to each other.
WHIA0255E
SRC-30
< COMPONENT DIAGNOSIS >
B1198 – B1201 SIDE CURTAIN AIR BAG MODULE LH (FRONT)
DTC CONFIRMATION PROCEDURE (Without CONSULT-lll)
NOTE:
SRS will not enter diagnosis mode if no malfunction is detected in user mode.
1.
IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 2
2.
IGNITION SWITCH
After air bag warning lamp lights for 7 seconds, turn ignition switch OFF within 1 second.
>> GO TO 3
3.
WAIT TIME
Wait more than 3 seconds.
>> GO TO 4
4.
REPEAT STEPS
Repeat steps 1 to 3 twice.
>> GO TO 5
5.
IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 6
6.
DIAGNOSTIC MODE
SRS system is now in diagnostic mode and AIR BAG warning lamp flashes. Refer to
.
>> END
Diagnosis Procedure (Component diagnosis)
INFOID:0000000001277791
Recheck SRS after each replacement.
1.
HARNESS CONNECTOR
Is there any visible damage to the connector?
YES or NO
YES
>> Replace the harness.
NO
>> GO TO 2
2.
WIRING HARNESS
Is there any visible damage to the harness?
YES or NO
YES
>> Replace the harness.
NO
>> GO TO 3
3.
LH SIDE CURTAIN AIR BAG MODULE
Replace the LH side curtain air bag module. Refer to
SR-11, "Removal and Installation"
.
>> GO TO 4
4.
AIR BAG DIAGNOSIS SENSOR UNIT
B1198 – B1201 SIDE CURTAIN AIR BAG MODULE LH (FRONT)
SRC-31
< COMPONENT DIAGNOSIS >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
Replace the air bag diagnosis sensor unit.
SR-15, "Removal and Installation"
.
>> GO TO 5
5.
RELATED HARNESS
Replace the related harness.
>> END
SRC-32
< COMPONENT DIAGNOSIS >
B1193 – B1196 SIDE CURTAIN AIR BAG MODULE RH (FRONT)
B1193 – B1196 SIDE CURTAIN AIR BAG MODULE RH (FRONT)
Description
INFOID:0000000001277792
DTC B1193 – B1196 RH SIDE CURTAIN AIR BAG MODULE (FRONT)
The RH side curtain air bag module (front) is wired to the air bag diagnosis sensor unit. The air bag diagnosis
sensor unit will monitor for opens and shorts in detected lines to the RH side curtain air bag module (front).
PART LOCATION
SRC-7, "SRS Component Parts Location"
DTC Logic
INFOID:0000000001277793
DTC DETECTION LOGIC
With CONSULT-lll
Without CONSULT-lll
DTC CONFIRMATION PROCEDURE (With CONSULT-lll)
1.
IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 2
2.
CONSULT-III
Select "DIAG MODE".
>> GO TO 3
3.
DTC
If DTC is detected. Refer to
SRC-33, "Diagnosis Procedure (Component diagnosis)"
.
>> END
CONSULT-III name
DTC
DTC detecting condition
Repair order
FR CURTN MODULE RH
[OPEN]
B1193
RH side curtain air bag module (front) cir-
cuit is open.
1.
Visually check the wiring harness connection.
2.
Replace the harness if it has visible damage.
3.
Replace the RH side curtain air bag module.
4.
Replace the air bag diagnosis sensor unit.
5.
Replace the related harness.
FR CURTN MODULE RH
[VB-SHORT]
B1194
RH side curtain air bag module (front) cir-
cuit is shorted to a power supply circuit.
FR CURTN MODULE RH
[GND-SHORT]
B1195
RH side curtain air bag module (front) cir-
cuit is shorted to ground.
FR CURTN MODULE RH
[SHORT]
B1196
RH side curtain air bag module (front) cir-
cuits are shorted to each other.
WHIA0253E
B1193 – B1196 SIDE CURTAIN AIR BAG MODULE RH (FRONT)
SRC-33
< COMPONENT DIAGNOSIS >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
DTC CONFIRMATION PROCEDURE (Without CONSULT-lll)
NOTE:
SRS will not enter diagnosis mode if no malfunction is detected in user mode.
1.
IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 2
2.
IGNITION SWITCH
After air bag warning lamp lights for 7 seconds, turn ignition switch OFF within 1 second.
>> GO TO 3
3.
WAIT TIME
Wait more than 3 seconds.
>> GO TO 4
4.
REPEAT STEPS
Repeat steps 1 to 3 twice.
>> GO TO 5
5.
IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 6
6.
DIAGNOSTIC MODE
SRS system is now in diagnostic mode and AIR BAG warning lamp flashes. Refer to
.
>> END
Diagnosis Procedure (Component diagnosis)
INFOID:0000000001277794
Recheck SRS after each replacement.
1.
HARNESS CONNECTOR
Is there any visible damage to the connector?
YES or NO
YES
>> Replace the harness.
NO
>> GO TO 2
2.
WIRING HARNESS
Is there any visible damage to the harness?
YES or NO
YES
>> Replace the harness.
NO
>> GO TO 3
3.
RH SIDE CURTAIN AIR BAG MODULE
Replace the RH side curtain air bag module. Refer to
SR-11, "Removal and Installation"
>> GO TO 4
4.
AIR BAG DIAGNOSIS SENSOR UNIT
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст