Nissan Versa Note. Manual — part 253
BACK DOOR LOCK
DLK-297
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
• Tighten outside handle bolts to specification. Refer to
.
• After installation, check back door open/close and lock/unlock operation.
EMERGENCY LEVER
EMERGENCY LEVER : Removal and Installation
INFOID:0000000009645214
UNLOCK PROCEDURE
NOTE:
If back door lock cannot be unlocked due to a malfunction or battery discharge, perform the following proce-
dure to unlock back door assembly.
From inside the vehicle, using a suitable tool, rotate the emergency
lever (1) in a clockwise direction to unlock the back door assembly.
AWKIA2577ZZ
DLK-298
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
FUEL FILLER LID OPENER
FUEL FILLER LID OPENER
Exploded View
INFOID:0000000009645215
FUEL FILLER LID
FUEL FILLER LID : Removal and Installation
INFOID:0000000009645216
REMOVAL
1. Remove fuel cap pin (1).
1.
Fuel filler lid lock release cable
2.
Fuel filler lid lock
3.
Fuel filler lid bumper
4.
Fuel filler lid spring
5.
Fuel filler lid
A.
Clip
B.
Cable protector
Pawl
AWKIA2582ZZ
ALKIA3198ZZ
FUEL FILLER LID OPENER
DLK-299
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
2. Remove fuel filler lid screws (A) and fuel filler lid (1).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation, check fuel filler lid assembly open/close and lock/unlock operation.
FUEL FILLER OPENER CABLE
FUEL FILLER OPENER CABLE : Removal and Installation
INFOID:0000000009645217
REMOVAL
1. Remove hood lock/fuel filler lid lock release handle. Refer to
DLK-161, "HOOD LOCK RELEASE HAN-
DLE : Removal and Installation"
2. Disconnect fuel filler lid opener cable (2) from hood lock/fuel
filler lid lock release handle (1).
3. Remove dash side finisher (LH). Refer to
INT-24, "DASH SIDE FINISHER : Removal and Installation"
4. Remove center pillar lower finisher (LH). Refer to
INT-25, "CENTER PILLAR LOWER FINISHER :
.
5. Remove luggage side lower finisher (LH). Refer to
INT-34, "LUGGAGE SIDE LOWER FINISHER :
.
6. Disconnect fuel filler lid opener cable (1) by pulling downward
and then sliding cable end to the side to remove from fuel filler
lid lock assembly (2).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation, check fuel filler lid assembly open/close, lock/unlock operation.
FUEL FILLER LID LOCK
ALKIA3199ZZ
JMKIA7999ZZ
JMKIA8139ZZ
DLK-300
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
FUEL FILLER LID OPENER
FUEL FILLER LID LOCK : Removal and Installation
INFOID:0000000009645218
REMOVAL
1. Fully open fuel filler lid.
2. Remove luggage side lower finisher (LH). Refer to
INT-34, "LUGGAGE SIDE LOWER FINISHER :
.
3. Disconnect the harness connector from the fuel filler lid lock assemby.
4. Release pawls (A) and remove fuel filler lid lock assembly (1).
CAUTION:
Be careful not to damage gasket (2) when removing.
5. Disconnect fuel filler lid opener cable (1) by pulling downward
and then sliding cable end to the side to remove from fuel filler
lid lock assembly (2).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation, check fuel filler lid assembly open/close, lock/unlock operation.
JMKIA8138ZZ
JMKIA8139ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст