Nissan Frontier D22. Manual — part 111
OVERHAUL
AT-413
[RE4R01A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Locations of Needle Bearings, Thrust Washers and Snap Rings
ECS007PA
WAT378
AT-414
[RE4R01A]
OVERHAUL
Disassembly
ECS007PB
1.
Drain ATF through drain plug.
2.
Remove turbine revolution sensor (VG33ER only).
3.
Remove torque converter by holding it firmly and turning while
pulling straight out.
4.
Check torque converter one-way clutch.
a.
Insert Tool into spline of one-way clutch inner race.
b.
Hook bearing support unitized with one-way clutch outer race
with suitable wire.
c.
Check that one-way clutch inner race rotates only clockwise with
Tool while holding bearing support with wire.
5.
Remove park/neutral position (PNP) switch from transmission
case.
6.
Remove oil pan.
●
Always place oil pan straight down so that foreign particles
inside will not move.
●
Always replace oil pan bolts as they are self-sealing bolts.
SAT018B
SAT521G
AAT562A
SAT754I
OVERHAUL
AT-415
[RE4R01A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
7.
Place transmission into Tool with the control valve facing up.
8.
Check foreign materials in oil pan to help determine cause of
malfunction. If the fluid is very dark, smells burned, or contains
foreign particles, the frictional material (clutches, band) may
need replacement. A tacky film that will not wipe clean indicates
varnish build up. Varnish can cause valves, servo, and clutches
to stick and may inhibit pump pressure.
●
If frictional material is detected, replace radiator after repair
of A/T. Refer to
CO-30, "Removal and Installation"
9.
Remove torque converter clutch solenoid valve and A/T fluid
temperature sensor connectors.
●
Be careful not to damage connector.
10. Remove oil strainer.
a.
Remove oil strainer from control valve assembly.
Then remove O-ring from oil strainer.
SAT522G
SAT171B
AAT561A
SAT008B
AT-416
[RE4R01A]
OVERHAUL
b.
Check oil strainer screen for damage.
11. Remove control valve assembly.
a.
Straighten terminal clips to free terminal cords then remove ter-
minal clips.
b.
Remove bolts A and B, and remove control valve assembly from
transmission.
c.
Remove solenoid connector.
●
Be careful not to damage connector.
SAT025B
SAT009B
Bolt symbol
Length mm (in)
A
33 (1.30)
B
45 (1.77)
SAT353B
SAT026B
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст