Nissan Frontier D22. Manual — part 737
TENSION ROD
FSU-23
C
D
F
G
H
I
J
K
L
M
A
B
FSU
TENSION ROD
PFP:54010
Removal and Installation
EES000X0
1.
Remove fixing nuts on lower link and frame.
Support lower link with jack.
2.
Install tension rod.
Make sure that the bushings and washers are installed
properly.
Inspection
EES000X1
●
Check tension rod for deformation and cracks. Replace if necessary.
●
Check rubber bushings for damage. Replace if necessary.
ASU054
Refer to
.
SFA846B
FSU-24
LOWER LINK
LOWER LINK
PFP:55020
Removal and Installation
EES000X2
1.
Remove torsion bar spring.
Make matching marks and measure dimension “L” when
loosening adjusting nut until there is no tension on torsion
bar spring.
2.
Remove shock absorber lower fixing bolt.
3.
Remove stabilizer bar connecting bolt.
4.
Separate drive shaft from front final drive (4WD models).
5.
Separate lower link ball joint from knuckle spindle.
6.
Remove front lower link fixing nut.
Refer to
.
WSU020
Standard length “L”
: 68 mm (2.68 in)
Refer to
Refer to
WSU021
ASU055
WSU024
LOWER LINK
FSU-25
C
D
F
G
H
I
J
K
L
M
A
B
FSU
7.
Remove bushing of lower link spindle from frame with Tool.
8.
After installing lower link, adjust wheel alignment and vehicle
height.
Inspection
EES000X3
LOWER LINK AND LOWER LINK SPINDLE
Check for deformation and cracks. Replace if necessary.
LOWER LINK BUSHING
Check for distortion and damage. Replace if necessary.
Refer to
and
"2WD AND 4WD VG33E AND VG33ER MODELS"
Refer to
FSU-10, "Front Wheel Alignment"
AFA138
FSU-26
UPPER BALL JOINT AND LOWER BALL JOINT
UPPER BALL JOINT AND LOWER BALL JOINT
PFP:40110
Removal and Installation
EES000X4
Separate knuckle spindle from upper and lower links.
Inspection
EES000X5
●
Check joints for play. If ball is worn and play in axial direction is excessive or joint is hard to swing, replace
as a upper link or lower link.
●
Check dust cover for damage.
Replace dust cover and dust cover clamp if necessary.
Refer to
AFA136
Axial end play “C”:
Upper link
: 0 mm (0 in)
Lower link
: 2WD KA24DE model 1.3
mm (0.051 in) or less
: 2WD and 4WD VG33E
and VG33ER models 0.2
mm (0.008 in) or less
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст