Nissan Frontier D22. Manual — part 199
TROUBLE DIAGNOSIS
BRC-127
[VDC/TCS/ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
2.
CHECK PERFORMANCE
Cancel VDC/TCS operation using VDC OFF switch and drive vehicle.
Is engine acceleration still poor?
YES
>> Refer to EC section.
NO
>> GO TO 3.
3.
CHECK SELF-DIAGNOSIS (TCM)
Perform self-diagnostic procedures for TCM.
Do any self-diagnosis results display?
YES
>> Refer to AT Section.
NO
>> GO TO 4.
4.
CHECK SELF-DIAGNOSIS (VDC/TCS/ABS)
Perform self-diagnostic procedures for VDC/TCS/ABS.
Do any self-diagnosis results display?
YES
NO
>> Inspection END.
BRC-128
[VDC/TCS/ABS]
REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
PFP:00000
Front Wheel Sensor
EFS003J6
CAUTION:
Be careful not to damage sensor edge and sensor rotor teeth. When removing the front or rear wheel
hub assembly, disconnect the ABS wheel sensor from the assembly and move it away.
Rear Wheel Sensor
EFS003J7
CAUTION:
Be careful not to damage sensor edge and sensor rotor teeth. When removing the front or rear wheel
hub assembly, disconnect the ABS wheel sensor from the assembly and move it away.
Front Sensor Rotor
EFS003J8
REMOVAL
CAUTION:
Be careful not to damage sensor edge and sensor rotor teeth. When removing the front or rear wheel
hub assembly, disconnect the ABS wheel sensor from the assembly and move it away.
ABR869
ABR868
REMOVAL AND INSTALLATION
BRC-129
[VDC/TCS/ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
1.
Remove the front wheel hub. Refer to
2.
Remove the sensor rotor using suitable puller, drift and bearing
replacer.
INSTALLATION
Install the sensor rotor using suitable drift and press.
●
Always replace sensor rotor with new one.
●
Pay attention to the direction of front sensor rotor as shown in
figure.
Rear Sensor Rotor
EFS003J9
REMOVAL
CAUTION:
Be careful not to damage sensor edge and sensor rotor teeth. When removing the front or rear wheel
hub assembly, disconnect the ABS wheel sensor from the assembly and move it away.
●
Remove the sensor rotor using Tool.
INSTALLATION
Install the sensor rotor using suitable drift and press.
●
Always replace sensor rotor with a new one.
●
Pay attention to the direction of front sensor rotor as shown in
figure.
SBR873C
SBR400DA
ARA097
SBR402D
BRC-130
[VDC/TCS/ABS]
REMOVAL AND INSTALLATION
ABS Actuator and Electric Unit
EFS003JA
REMOVAL
1.
Disconnect battery cable.
2.
Disconnect connector and brake pipes.
3.
Remove fixing bolts.
INSTALLATION
CAUTION:
After installation, refill brake fluid. Then bleed air. Refer to
BR-10, "Bleeding Brake System"
1.
Connect brake pipes temporarily.
2.
Tighten fixing bolts.
3.
Tighten brake pipes.
4.
Connect connector and battery cable.
5.
Adjust steering angle sensor neutral position. Refer to
BRC-55, "Adjustment of Steering Angle Sensor
LFIA0133E
Tightening torque
: 16.7 - 21.6 N·m (1.7 - 2.2 kg-m, 13 - 15 ft-lb)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст