Nissan Frontier D22. Manual — part 113
OVERHAUL
AT-421
[RE4R01A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
c.
Remove oil seal from adapter case or rear extension.
●
Do not remove oil seal unless it is to be replaced.
d.
Remove revolution sensor from adapter case or rear extension.
e.
Remove O-ring from revolution sensor.
20. Remove output shaft and parking gear.
a.
Remove rear snap ring from output shaft.
b.
Slowly push output shaft all the way forward.
●
Do not use excessive force.
c.
Remove snap ring from output shaft.
d.
Remove output shaft and parking gear as a unit from transmis-
sion case.
e.
Remove parking gear from output shaft.
SAT146GA
SAT147G
SAT960A
SAT957A
SAT109B
AT-422
[RE4R01A]
OVERHAUL
f.
Remove needle bearing from transmission case.
21. Remove rear side clutch and gear components.
a.
Remove front internal gear.
b.
Remove bearing race from front internal gear.
c.
Remove needle bearing from rear internal gear.
d.
Remove rear internal gear, forward clutch hub and overrun
clutch hub as a set from transmission case.
SAT033B
SAT954A
SAT110B
SAT111B
SAT951A
OVERHAUL
AT-423
[RE4R01A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
e.
Remove needle bearing from overrun clutch hub.
f.
Remove overrun clutch hub from rear internal gear and forward
clutch hub.
g.
Remove thrust washer from overrun clutch hub.
h.
Remove forward clutch assembly from transmission case.
22. Remove band servo and accumulator components.
a.
Remove band servo retainer from transmission case.
b.
Apply compressed air to oil hole until band servo piston comes
out of transmission case.
●
Hold piston with a rag and gradually direct air to oil hole.
c.
Remove return springs.
SAT148G
SAT036B
SAT037B
SAT038B
SAT039B
AT-424
[RE4R01A]
OVERHAUL
d.
Remove springs from accumulator pistons B, C and D.
e.
Apply compressed air to each oil hole until piston comes out.
●
Hold piston with a rag and gradually direct air to oil hole.
f.
Remove O-ring from each piston.
23. Remove manual shaft components, if necessary.
a.
Hold width across flats of manual shaft (outside the transmission
case) and remove lock nut from shaft.
b.
Remove retaining pin from transmission case.
c.
While pushing detent spring down, remove manual plate and
parking rod from transmission case.
Identification of accumulator pistons
A
B
C
D
Identification of oil holes
a
b
c
d
SAT040BA
SAT523GA
SAT041B
SAT042B
SAT935A
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст