Nissan Frontier D22. Manual — part 108
KEY INTERLOCK CABLE
AT-401
[RE4R01A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Installation
ECS007OY
1.
Set key interlock cable to steering lock assembly and install lock
plate.
2.
Clamp cable to steering column and fix to control cable with
band.
3.
Set selector lever to P position.
4.
Insert interlock rod into adjuster holder.
5.
Install casing cap to bracket.
6.
Move slider in order to fix adjuster holder to interlock rod.
SAT354I
SAT355I
SAT356I
AT-402
[RE4R01A]
ON-VEHICLE SERVICE
ON-VEHICLE SERVICE
PFP:00000
Control Valve Assembly and Accumulators
ECS007OZ
REMOVAL
1.
Drain ATF through drain plug.
2.
Remove exhaust front tube.
3.
Remove oil pan and gasket.
●
Always replace oil pan bolts as they are self-sealing
bolts.
4.
Remove A/T fluid temperature sensor if necessary.
5.
Remove oil strainer.
6.
Remove control valve assembly by removing fixing bolts and
disconnecting harness connector.
SAT359I
SAT073BA
SAT353B
ON-VEHICLE SERVICE
AT-403
[RE4R01A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Bolt length and location
7.
Remove solenoids and valves from valve body if necessary.
8.
Remove terminal cord assembly if necessary.
9.
Remove accumulator A, B, C and D by applying compressed
air if necessary.
●
Hold each piston with rag.
10. Reinstall any part removed.
●
Always use new sealing parts.
●
Always replace oil pan bolts as they are self-sealing bolts.
Revolution Sensor Replacement
ECS007P0
—4WD MODEL—
1.
Remove rear engine mounting member from side member while supporting A/T with transfer case with
jack. Tighten rear engine mounting member to the specified torque. Refer to
2.
Lower A/T with transfer case as much as possible.
3.
Remove revolution sensor from A/T.
4.
Reinstall any part removed.
●
Always use new sealing parts.
—2WD MODEL—
●
Remove revolution sensor from A/T.
●
Always use new sealing parts.
Bolt symbol
mm (in)
A
33 (1.30)
B
45 (1.77)
SAT074BA
AAT565A
SAT661I
AT-404
[RE4R01A]
ON-VEHICLE SERVICE
Turbine Revolution Sensor Replacement (VG33ER only)
ECS007P1
1.
Remove A/T assembly. Refer to
2.
Remove turbine revolution sensor from A/T assembly upper
side.
3.
Reinstall any part removed.
●
Always use new sealing parts.
Rear Oil Seal Replacement
ECS007P2
—4WD MODEL—
1.
Remove transfer case from vehicle. Refer to
2.
Remove rear oil seal.
3.
Install rear oil seal.
●
Apply ATF before installing.
4.
Reinstall any part removed.
—2WD MODEL—
1.
Remove propeller shaft from vehicle. Refer to
2.
Remove rear oil seal.
3.
Install rear oil seal.
–
Apply ATF before installing.
4.
Reinstall any part removed.
SAT136K
SAT035E
SAT662I
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст