Nissan Rogue. Manual — part 659
FRONT FOG LAMP AIMING ADJUSTMENT
EXL-265
< PERIODIC MAINTENANCE >
[LED HEADLAMP]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
3. Access adjusting screw (A) from underneath front bumper fas-
cia. Adjust front fog lamps using adjusting screw so that the top
edge of the high intensity zone is at the front fog lamp centers
above ground.
ALLIA0035ZZ
EXL-266
< REMOVAL AND INSTALLATION >
[LED HEADLAMP]
FRONT COMBINATION LAMP
REMOVAL AND INSTALLATION
FRONT COMBINATION LAMP
Exploded View
INFOID:0000000011280908
Removal and Installation
INFOID:0000000011280909
REMOVAL
1. Remove front bumper fascia. Refer to
EXT-17, "Removal and Installation"
.
2. Remove front combination lamp bolts and clip.
3. Pull front combination lamp forward.
4. Disconnect the harness connectors from the front combination lamp and remove.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
After installation, perform headlamp aiming adjustment. Refer to
Bulb Replacement
INFOID:0000000011280910
HEADLAMP (LOW BEAM) BULB
The headlamp (low beam) bulb is not serviced separately. Refer to
EXL-266, "Removal and Installation"
.
HEADLAMP (HIGH BEAM) BULB
The headlamp (high beam) bulb is not serviced separately. Refer to
EXL-266, "Removal and Installation"
1.
Front fender
2.
Front combination lamp
Clip
ALLIA1401ZZ
FRONT COMBINATION LAMP
EXL-267
< REMOVAL AND INSTALLATION >
[LED HEADLAMP]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
SIDE MARKER LAMP BULB
The side marker lamp bulb is not serviced separately. Refer to
EXL-266, "Removal and Installation"
TURN SIGNAL LAMP BULB
Removal
1. Rotate bulb socket counterclockwise and remove from the front combination lamp.
2. Remove the bulb from bulb socket.
Installation
Installation is in the reverse order of removal.
CAUTION:
After installing the bulb, install the bulb socket securely for watertightness.
EXL-268
< REMOVAL AND INSTALLATION >
[LED HEADLAMP]
HEIGHT SENSOR
HEIGHT SENSOR
Exploded View
INFOID:0000000011280911
Removal and Installation - Rear Height Sensor
INFOID:0000000011280912
REMOVAL
1. Disconnect the harness connector from the rear height sensor.
2. Remove the bolts and rear height sensor.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Perform the sensor initialize of the headlamp aiming control system. Refer to
.
1.
Rear suspension member
2.
Rear height sensor
A.
Harness connector
Locator
AWLIA2324ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст