Nissan Rogue. Manual — part 977
PG
BATTERY
PG-71
< BASIC INSPECTION >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
Charging The Battery
CAUTION:
• Never “quick charge” a fully discharged battery.
• Keep the battery away from open flame while it is being charged.
• When connecting the charger, connect the leads first, then turn on the charger. Never turn on the
charger first, as this may cause a spark.
• If battery electrolyte temperature rises above 55
°C (131 °F), stop charging. Always charge battery at
a temperature below 55
°C (131 °F).
Charging Rates (Standard Charge)
Charging Rates (Quick Charge)
NOTE:
The ammeter reading on your battery charger will automatically decrease as the battery charges. This indi-
cates that the voltage of the battery is increasing normally as the state of charge improves. The charging amps
indicated above refer to initial charge rate.
• If, after charging, the specific gravity of any two cells varies more than 0.050, the battery should be replaced.
4 (40)
−0.016
−1 (30)
−0.020
−7 (20)
−0.024
−12 (10)
−0.028
−18 (0)
−0.032
Battery electrolyte temperature [
°C (°F)]
Add to specific gravity reading
Corrected specific gravity
Approximate charge condition
1.260 - 1.280
Fully charged
1.230 - 1.250
3/4 charged
1.200 - 1.220
1/2 charged
1.170 - 1.190
1/4 charged
1.140 - 1.160
Almost discharged
1.110 - 1.130
Completely discharged
Approximate charge condi-
tion
Charge current (A)
Charge time (h)
Fully charged
7
2
3/4 charged
2.5
1/2 charged
5
1/4 charged
7.5
Almost discharged
9
Completely discharged
10
Approximate charge condi-
tion
Charge current (A)
Charge time (h)
Fully charged
—
—
3/4 charged
16
0.5
1/2 charged
33
1/4 charged
Almost discharged
Completely discharged
—
—
PG-72
< BASIC INSPECTION >
INSPECTION AND ADJUSTMENT
INSPECTION AND ADJUSTMENT
ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL
ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Spe-
cial Repair Requirement
INFOID:0000000011280957
Required Procedure After Battery Disconnection
System
Item
Reference
Engine Control System
Idle Air Volume Learning
Door & Lock
Calibration Of Automatic Back Door Position
Information
Power Window Control System
Power Window System Initialization
Roof
Moonroof Memory Reset/Initialization
Sunshade Memory Reset/Initialization
Heater & Air Conditioning Control System
Temperature Setting Trimmer
(Automatic air conditioning)
Foot Position Setting Trimmer
(Automatic air conditioning)
Inlet Port Memory Function (FRE)
(Automatic air conditioning)
Inlet Port Memory Function (REC)
(Automatic air conditioning)
Target Evaporator Temp Upper Limit
(Automatic air conditioning)
(Manual air conditioning)
Audio, Visual and Navigation System
Audio (Radio Preset)
Refer to Owner's Manual.
Navigation System
Refer to Owner's Manual.
PG
FUSE INSPECTION
PG-73
< BASIC INSPECTION >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
FUSE INSPECTION
How To Check
INFOID:0000000011280958
• If fuse is blown, be sure to eliminate cause of malfunction before
installing new fuse.
• Use fuse of specified rating. Never use fuse of more than specified
rating.
• Do not partially install fuse; always insert it into fuse holder prop-
erly.
• Remove fuse for “ELECTRICAL PARTS (BAT)” if vehicle is not
used for a long period of time.
EXTENDED STORAGE FUSE SWITCH (IF EQUIPPED)
The following switch may be mounted on the fuse block (Junction Box) for transportation and storage.
Remove the extended storage fuse switch if it causes the interference when checking fuses.
How To Extended Storage Fuse Switch ON/OFF
CAUTION:
• Turn the ignition switch OFF when operating the extended storage fuse switch.
• Under normal conditions, keep the extended storage fuse switch in ON state. Never operate the
extended storage fuse switch except when necessary.
CEL083
Extended storage fuse switch
Type A
Type B
Type C
JSMIA0793ZZ
PG-74
< BASIC INSPECTION >
FUSE INSPECTION
• Type A
- To turn the extended storage fuse switch OFF, pull it up in direction as shown in the figure.
- To turn the extended storage fuse switch ON, press it in direction as shown in the figure.
• Type B
- To turn the extended storage fuse switch OFF, hold of the switch and pull up in direction as shown in
the figure.
- To turn the extended storage fuse switch ON, press it in direction as shown in the figure.
• Type C
- To turn the extended storage fuse switch OFF, pull it up in direction as shown in the figure.
- To turn the extended storage fuse switch ON, press it in direction as shown in the figure.
How To Remove Extended Storage Fuse Switch
Type A
JSMIA0472ZZ
JSMIA0473ZZ
JSMIA0794ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст