Nissan Qashqai J11. Manual — part 2205
DAS-234
< WIRING DIAGRAM >
[CHASSIS CONTROL]
CHASSIS CONTROL
WIRING DIAGRAM
CHASSIS CONTROL
Wiring Diagram
INFOID:0000000010416980
JROWC2551GB
DAS
CHASSIS CONTROL
DAS-235
< WIRING DIAGRAM >
[CHASSIS CONTROL]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
JROWC2210GB
DAS-236
< WIRING DIAGRAM >
[CHASSIS CONTROL]
CHASSIS CONTROL
JROWC2211GB
DAS
DIAGNOSIS AND REPAIR WORK FLOW
DAS-237
< BASIC INSPECTION >
[CHASSIS CONTROL]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
BASIC INSPECTION
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
INFOID:0000000010416981
DETAILED FLOW
1.
INTERVIEW FROM THE CUSTOMER
Clarify customer complaints before inspection. First of all, perform an interview utilizing
and reproduce the symptom as well as fully understand it. Ask customer about his/her complaints
carefully. Check symptoms by driving vehicle with customer, if necessary.
CAUTION:
Customers are not professional. Never guess easily like “maybe the customer means that...,” or
“maybe the customer mentions this symptom”.
>> GO TO 2.
2.
CHECK SYMPTOM
Reproduce the symptom that is indicated by the customer, based on the information from the customer
obtained by the interview. Also check that the symptom is not caused by fail-safe mode. Refer to
"Fail-Safe (Chassis Control Module)"
CAUTION:
When the symptom is caused by normal operation, fully inspect each portion and obtain the under-
standing of customer that the symptom is not caused by a malfunction.
>> GO TO 3.
3.
PERFORM SELF-DIAGNOSIS
With CONSULT
1.
Perform “Self Diagnostic Result“ for “CHASSIS CONTROL“.
Is DTC detected?
YES
>> Record or print self-diagnosis results and freeze frame data (FFD). GO TO 4.
NO
>> Inspection End.
4.
RECHECK THE SYMPTOM
With CONSULT
Perform DTC confirmation procedures for the malfunctioning system.
NOTE:
If some DTCs are detected at the some time, determine the order for performing the diagnosis based on
231, "DTC Inspection Priority Chart"
.
Is DTC detected?
YES
>> GO TO 5.
NO
>> Check harness and connectors based on the information obtained by the interview. Refer to
210, "Precautions for Harness Repair"
.
5.
REPAIR OR REPLACE MALFUNCTIONING PARTS
1.
Repair or replace malfunctioning parts.
2.
Reconnect part or connector after repairing or replacing.
3.
When DTC is detected, erase “Self Diagnostic Result“ for “CHASSIS CONTROL”.
>> GO TO 6.
6.
FINAL CHECK
With CONSULT
1.
Check the reference value for “CHASSIS CONTROL”.
2.
Recheck the symptom and check that the symptom is not reproduced on the same conditions.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст