Nissan Qashqai J11. Manual — part 1716
FRONT FOG LAMP
EXL-165
< REMOVAL AND INSTALLATION >
[LED HEADLAMP]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
• Disconnect the battery negative terminal or remove power circuit fuse when performing the opera-
tion for preventing electric leakage. Refer to
EXL-8, "Precautions for Removing Battery Terminal"
.
• Never touch the glass of bulb directly by hand. Keep grease and other oily matters away from it.
• Never touch bulb by hand while it is lit or right after being turned OFF.
• Never leave bulb out of lamp reflector for a long time because dust, moisture smoke, etc. may affect
the performance of lamp. When replacing bulb, be sure to replace it with new one.
FRONT FOG LAMP BULB
1.
Remove fender protector to make work space. Refer to
EXT-32, "Removal and Installation"
.
2.
Disconnect front fog lamp harness connector
.
3.
Rotate front fog lamp bulb
counterclockwise and unlock it.
JPLIA0345ZZ
EXL-166
< REMOVAL AND INSTALLATION >
[LED HEADLAMP]
SIDE TURN SIGNAL LAMP
SIDE TURN SIGNAL LAMP
Exploded View
INFOID:0000000010338861
.
Removal and Installation
INFOID:0000000010338862
REMOVAL
1.
Remove door mirror cover. Refer to
MIR-31, "Removal and Installation"
.
2.
Remove side turn signal lamp fixing screws.
3.
Remove seal packing
and disconnect side turn signal lamp
harness connector
, and then remove side turn signal lamp
from door mirror housing.
INSTALLATION
Install in the reverse order of removal.
Replacement
INFOID:0000000010338863
CAUTION:
Replacement of a single part is not possible due to the adoption of LED bulb. For replacement, replace
side turn signal lamp as a set.
SIDE TURN SIGNAL LAMP
1.
Remove side turn signal lamp. Refer to
MIR-31, "Removal and Installation"
2.
Replace side turn signal lamp with new part.
JMLIA4978ZZ
LIGHTING & TURN SIGNAL SWITCH
EXL-167
< REMOVAL AND INSTALLATION >
[LED HEADLAMP]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
LIGHTING & TURN SIGNAL SWITCH
Removal and Installation
INFOID:0000000010338866
REMOVAL
Remove light & turn signal switch (combination switch). Refer to
BCS-133, "Removal and Installation"
.
INSTALLATION
Install in the reverse order of removal.
EXL-168
< REMOVAL AND INSTALLATION >
[LED HEADLAMP]
HAZARD SWITCH
HAZARD SWITCH
Exploded View
INFOID:0000000010427649
Removal and Installation
INFOID:0000000010427650
REMOVAL
1.
Remove center ventilator grille. Refer to
IP-13, "Removal and Installation"
.
2.
Disengage fixing pawls, and then remove hazard switch from center ventilator grille.
INSTALLATION
Install in the reverse order of removal.
Center ventilator grille
Hazard switch
: Pawl
JMLIA5094ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст