Nissan Qashqai J11. Manual — part 788
DLN-68
< SYMPTOM DIAGNOSIS >
[TRANSFER: TY21C]
TIRE SIZE INCORRECT IS DISPLAYED ON INFORMATION DISPLAY
TIRE SIZE INCORRECT IS DISPLAYED ON INFORMATION DISPLAY
Description
INFOID:0000000010755293
While driving, 4WD warning (Tire Size Incorrect: See Owner’s Manual) is displayed on information display
(combination meter).
Diagnosis Procedure
INFOID:0000000010755294
1.
CHECK TIRE
Check the following.
• Tire pressure
• Wear condition
• Front and rear tire size (There is no difference between front and rear tires.)
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair or replace error-detected parts. And then, drive the vehicle at speed of 20 km/h (12 MPH)
or more for 5 seconds or more. Improper size information is initialized accordingly.
2.
CHECK INPUT SIGNAL OF TIRE DIAMETER
With CONSULT
1.
Start the engine.
2.
Drive at 20 km/h (12 MPH) or more for approximately 4 minutes continually.
3.
Check “DIS-TIRE MONI” of CONSULT “DATA MONITOR” for “ALL MODE AWD/4WD”.
Does the item on “DATA MONITOR” indicate “0 - 4 mm”?
YES
>> INSPECTION END
NO
>> GO TO 3.
3.
TERMINAL INSPECTION
Check 4WD control unit harness connector for disconnection.
Is the inspection result normal?
YES
>> Replace 4WD control unit. Refer to
DLN-72, "Removal and Installation"
NO
>> Repair or replace the error-detected parts.
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
DLN-69
< SYMPTOM DIAGNOSIS >
[TRANSFER: TY21C]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
INFOID:0000000010755295
Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If nec-
essary, repair or replace these parts.
Reference
—
,
,
SUSPECTED PARTS
(Possible cause)
T
R
ANSFER OIL (Level
low)
T
R
ANSFER OIL (W
rong)
T
R
ANSFER OIL (Level
too high)
LI
QUI
D
GASKET
(Dam
ag
ed
)
O-RING (W
o
rn o
r da
m
age
d)
OIL
SEA
L (W
o
rn o
r da
m
age
d)
GEAR
(W
orn
o
r
da
ma
ge
d)
B
EARING (W
orn
or
da
ma
ge
d)
Symptom
Noise
1
2
3
3
3
Transfer oil leakage
3
1
2
2
2
DLN-70
< PERIODIC MAINTENANCE >
[TRANSFER: TY21C]
TRANSFER OIL
PERIODIC MAINTENANCE
TRANSFER OIL
Inspection
INFOID:0000000010590215
OIL LEAKS
Check that oil is not leaking from transfer assembly or around it.
OIL LEVEL
CAUTION:
Do not start engine while checking oil level.
1.
Remove filler plug (1).
2.
Oil level (A) should be level with bottom of filler plug hole. Add
oil if necessary. Refer to
MA-59, "Fluids and Lubricants"
3.
Clean threads of filler plug (1) and transfer case.
4.
Apply sealant to the threads of the filler plug (1) and install it.
Tighten to specified torque. Refer to
Use Genuine Silicone RTV Sealant or equivalent. Refer to
MA-59, "Fluids and Lubricants"
.
Draining
INFOID:0000000010590216
CAUTION:
Do not start engine while checking oil level.
1.
Run the vehicle to warm up the transfer unit sufficiently.
2.
Stop the engine and remove drain plug (1) and drain the transfer
oil.
3.
Clean threads of drain plug (1) and transfer case.
4.
Apply sealant to the threads of the drain plug (1) and install it.
Tighten to specified torque. Refer to
Use Genuine Silicone RTV Sealant or equivalent. Refer to
MA-59, "Fluids and Lubricants"
.
Refilling
INFOID:0000000010590217
CAUTION:
Do not start engine while checking oil level.
1.
Remove filler plug (1).
2.
Fill with new oil to the specified level (A) near the filler plug hole.
3.
Clean threads of filler plug (1) and transfer case.
4.
Apply sealant to the threads of the filler plug (1), and install it. Tighten to specified torque. Refer to
: Front
ALDIA0383ZZ
: Front
ALDIA0382ZZ
: Front
Oil grade and viscosity
: Refer to
.
Oil capacity
: Refer to
.
ALDIA0383ZZ
TRANSFER OIL
DLN-71
< PERIODIC MAINTENANCE >
[TRANSFER: TY21C]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
Use Genuine Silicone RTV Sealant or equivalent. Refer to
MA-59, "Fluids and Lubricants"
.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст