Nissan Qashqai J11. Manual — part 2189
DAS-170
< DTC/CIRCUIT DIAGNOSIS >
[DRIVER ASSISTANCE SYSTEM]
C1A05 BRAKE SW/STOP LAMP SW
C1A05 BRAKE SW/STOP LAMP SW
DTC Logic
INFOID:0000000010416906
DTC DETECTION LOGIC
NOTE:
If DTC C1A05 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to
126, "DISTANCE SENSOR : DTC Logic"
.
Diagnosis Procedure
INFOID:0000000010416907
1.
CHECK ECM SELF DIAGNOSTIC RESULT
1.
Perform “Self Diagnostic Result” of “ENGINE” using CONSULT.
Are any DTCs detected?
YES
>> Refer to
(K9K) or
(R9M).
NO
>> GO TO 2.
2.
CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF DIAGNOSTIC RESULT
1.
Perform “Self Diagnostic Result” of “ABS” using CONSULT.
Are any DTCs detected?
YES
>> Refer to
.
NO
>> Replace distance sensor. Refer to
DAS-203, "Removal and Installation"
.
CONSULT Display
DTC Detection Condition
Possible Cause
BRAKE SW/STOP L SW
[C1A05]
Mismatch between stop lamp switch signal and
brake switch signal received from ECM and stop
lamp switch signal received from ABS actuator
and electric unit (control unit) that continues for
10 seconds or more with vehicle speeds at ap-
proximately 40 km/h or more.
• ECM.
• ABS actuator and electric unit (control unit).
• Distance sensor.
DAS
C1A07 CVT
DAS-171
< DTC/CIRCUIT DIAGNOSIS >
[DRIVER ASSISTANCE SYSTEM]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
C1A07 CVT
DTC Logic
INFOID:0000000010769754
DTC DETECTION LOGIC
NOTE:
If DTC C1A07 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to
126, "FRONT CAMERA UNIT : DTC Logic"
.
1.
PERFORM SELF DIAGNOSTIC RESULT
1.
Start the engine.
2.
Drive the vehicle.
3.
Stop the vehicle.
4.
Perform “Self Diagnostic Result” of “LASER/RADAR” using CONSULT.
Is DTC detected?
YES
>> Refer to
DAS-171, "Diagnosis Procedure"
NO
>> Refer to
GI-41, "Intermittent Incident"
.
Diagnosis Procedure
INFOID:0000000010769755
1.
PERFORM TCM SELF DIAGNOSTIC RESULT
Perform “Self Diagnostic Result” of “TRANSMISSION” using CONSULT.
Are any DTCs detected?
YES
>> Refer to
(RE0F10D) or
NO
>> Replace distance sensor. Refer to
DAS-203, "Removal and Installation"
.
CONSULT Display
DTC detecting condition
Possible causes
CVT CIRCUIT
[C1A07]
TCM is malfunctioning.
• Accelerator pedal position sensor.
• TCM.
• Distance sensor.
DAS-172
< DTC/CIRCUIT DIAGNOSIS >
[DRIVER ASSISTANCE SYSTEM]
C1A12 LASER BEAM OFF CENTER
C1A12 LASER BEAM OFF CENTER
DTC Logic
INFOID:0000000010416908
DTC DETECTION LOGIC
Diagnosis Procedure
INFOID:0000000010416909
1.
PERFORM DISTANCE SENSOR SELF DIAGNOSTIC RESULT
Perform “Self Diagnostic Result” of “LASER/RADAR” using CONSULT.
Is DTC detected?
YES
>> Replace distance sensor. Refer to
DAS-203, "Removal and Installation"
.
NO
>> Inspection End.
CONSULT Display
DTC Detection Condition
Possible Cause
LASER BEAM OFF CNTR
[C1A12]
Distance sensor is off the aiming point.
Distance sensor.
DAS
C1A14 ECM
DAS-173
< DTC/CIRCUIT DIAGNOSIS >
[DRIVER ASSISTANCE SYSTEM]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
C1A14 ECM
AROUND VIEW MONITOR CONTROL UNIT
AROUND VIEW MONITOR CONTROL UNIT : DTC Logic
INFOID:0000000010416910
DTC DETECTION LOGIC
NOTE:
If DTC C1A14 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to
126, "AROUND VIEW MONITOR CONTROL UNIT : DTC Logic"
.
1.
PERFORM SELF DIAGNOSTIC RESULT
1.
Start the engine.
2.
Drive the vehicle.
3.
Stop the vehicle.
4.
Perform “Self Diagnostic Result” of “AVM” using CONSULT.
Is DTC detected?
YES
>> Refer to
DAS-173, "AROUND VIEW MONITOR CONTROL UNIT : Diagnosis Procedure"
NO
>> Refer to
GI-41, "Intermittent Incident"
.
AROUND VIEW MONITOR CONTROL UNIT : Diagnosis Procedure
INFOID:0000000010416911
1.
CHECK ECM SELF DIAGNOSTIC RESULT
Perform “Self Diagnostic Result” of “ENGINE” using CONSULT.
Are any DTCs detected?
YES
>> Refer to
(MR20DD),
(K9K) or
(R9M).
NO
>> Replace around view monitor control unit. Refer to
AV-267, "Removal and Installation"
DISTANCE SENSOR
DISTANCE SENSOR : DTC Logic
INFOID:0000000010632396
DTC DETECTION LOGIC
NOTE:
If DTC C1A14 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to
126, "FRONT CAMERA UNIT : DTC Logic"
.
1.
PERFORM SELF DIAGNOSTIC RESULT
1.
Start the engine.
2.
Drive the vehicle.
3.
Stop the vehicle.
4.
Perform “Self Diagnostic Result” of “LASER/RADAR” using CONSULT.
Is DTC detected?
YES
>> Refer to
DAS-174, "DISTANCE SENSOR : Diagnosis Procedure"
NO
>> Refer to
GI-41, "Intermittent Incident"
.
CONSULT Display
DTC detecting condition
Possible causes
ECM CIRCUIT
[C1A14]
ECM is malfunctioning.
• Accelerator pedal position sensor.
• ECM.
• Around view monitor control unit.
CONSULT Display
DTC detecting condition
Possible causes
ECM CIRCUIT
[C1A14]
ECM is malfunctioning.
• Accelerator pedal position sensor.
• ECM.
• Distance sensor.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст