Nissan Qashqai J11. Manual — part 1537
EXT-22
< REMOVAL AND INSTALLATION >
REAR BUMPER
REAR BUMPER
Exploded View
INFOID:0000000010377905
1.
Rear bumper fascia assembly
2.
Rear fillet molding (LH/RH)
3.
Reflector assembly
E1JIA0284ZZ
REAR BUMPER
EXT-23
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
Removal and Installation
INFOID:0000000010377906
REMOVAL
CAUTION:
Bumper fascia is made of resin. Do not apply strong force to it, and be careful to prevent contact with
oil.
1.
Fully open back door assembly.
2.
Remove rear bumper fixing screws.
3.
Remove rear bumper lower fixing screw (A) and clip (B) (LH/
RH).
4.
Remove rear bumper lower clips.
5.
Remove rear fillet molding (LH/RH). Refer to
EXT-37, "Removal and Installation"
.
6.
Remove rear fender protector fixing clips (LH/RH).
7.
Remove rear bumper upper fixing screw (A) (LH/RH).
8.
Remove rear combination lamp. Refer to
EXL-174, "Removal and Installation"
(Vehicle with xenon type),
EXL-330, "Removal and Installation"
(Vehicle with halogen type).
9.
Push forwards and then pull to release rear bumper from side
bracket B Refer to
4.
Rear tow hook
5.
Rear bumper harness (if equipped)
6.
Energy absorber
7.
Rear bumper stay assembly (LH/RH) 8.
Rear bumper side bracket assembly
(LH/RH)
9.
Rear bumper side retainer
E1KIA0013ZZ
E1KIA0015ZZ
E1KIA0016ZZ
EXT-24
< REMOVAL AND INSTALLATION >
REAR BUMPER
10. Release rear bumper clips (A).
11. Disconnect all harness connectors.
12. Remove rear bumper fascia assembly.
CAUTION:
When removing bumper fascia, 2 workers are required so as to prevent it from dropping.
13. Remove the following parts after removing rear bumper fascia.
• Rear bumper energy absorber
• Rear bumper side retainer (LH/RH)
• Rear bumper clips
• Rear bumper side bracket A (LH/RH)
• Reflector assembly (LH/RH)
• Rear bumper stays
• Tow Hook Cover
INSTALLATION
Install in the reverse order of removal.
E1KIA0017ZZ
FRONT GRILLE
EXT-25
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
FRONT GRILLE
Exploded View
INFOID:0000000010377907
Removal and Installation
INFOID:0000000010377908
REMOVAL
CAUTION:
Apply protection tape around outer circumference of front grille (bumper fascia side).
1.
Fully open hood assembly.
2.
Remove front grille upper fixing clips.
1.
Front grille molding
2.
Front emblem
3.
Front camera
4.
Front grille
5.
Fixing clip
Pawl
E1JIA0288ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст