Nissan Qashqai J11. Manual — part 875
WT-46
< DTC/CIRCUIT DIAGNOSIS >
[WITH TPMS]
LOW TIRE PRESSURE WARNING LAMP
LOW TIRE PRESSURE WARNING LAMP
Component Function Check
INFOID:0000000010339549
1.
CHECK THE ILLUMINATION OF THE LOW TIRE PRESSURE WARNING LAMP
Check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second,
when the ignition switch is turned ON.
Is the inspection result normal?
YES
>> INSPECTION END
NO
>> Perform trouble diagnosis. Refer to
Diagnosis Procedure
INFOID:0000000010339550
1.
POWER SUPPLY AND GROUND CIRCUIT
Check power supply and ground circuit. Refer to
BCS-125, "Diagnosis Procedure"
.
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair or replace damaged parts.
2.
PERFORM SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis for “AIR PRESSURE MONITOR”.
Is any DTC detected?
YES
>> Check the DTC. Refer to
NO
>> GO TO 3.
3.
CHECK LOW TIRE PRESSURE WARNING LAMP SIGNAL
With CONSULT
1.
Turn the ignition switch ON.
CAUTION:
Never start the engine.
2.
Select “ACTIVE TEST” in “AIR PRESSURE MONITOR”.
3.
Touch “WARNING LAMP” to turn ON the low tire pressure warning lamp.
When “ACTIVE TEST” is performed, does the low tire pressure warning lamp in the combination meter turn
ON?
YES
>> Perform combination meter diagnosis. Refer to
NO
TPMS
WT-47
< SYMPTOM DIAGNOSIS >
[WITH TPMS]
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
SYMPTOM DIAGNOSIS
TPMS
Symptom Table
INFOID:0000000010339552
LOW TIRE PRESSURE WARNING LAMP SYMPTOM CHART
WT-48
< SYMPTOM DIAGNOSIS >
[WITH TPMS]
TPMS
Diagnosis items
Symptom
(Ignition switch
ON)
Low tire pressure warning lamp
Cause
Action
Low tire pres-
sure warning
lamp
The low tire pres-
sure warning lamp
illuminates for 1
second, then turns
OFF.
Wake-up operation for all
tire pressure sensors at
wheels is completed.
No system malfunctions
The low tire pres-
sure warning lamp
turns ON and stays
illuminated.
Low tire pressure
Check the tire pressure for
all wheels and adjust to the
specified value. Refer to
.
Tire pressure monitoring
system configuration do
not be performed.
Perform configuration. Re-
fer to
.
Tire pressure sensor ID
registration do not be
performed.
Perform ID registration. Re-
fer to
.
The low tire pres-
sure warning lamp
repeats blinking at
0.5-second inter-
vals for 1 minute,
and then stays illu-
minated.
The BCM cannot detect
tire pressure data signal.
• Check visually that the
tire pressure sensors are
installed. If necessary, re-
place/install the tire pres-
sure sensor(s) and
perform tire pressure
sensor ID registration.
Refer to
.
• Remove the interference
radio wave (e.g. battery
charger of smart phone).
The combination meter
fuse is open or removed
(or pulled out).
Check and install the com-
bination meter fuse. If nec-
essary, replace the fuse.
The BCM harness con-
nector is removed.
Check the connection con-
ditions of the BCM harness
connector, and repair if nec-
essary.
Tire Pressure Monitoring
System (TPMS) mal-
function.
(except tire pressure
monitoring system con-
figuration and/or tire
pressure sensor ID reg-
istration non-performed)
Perform CONSULT self-di-
agnosis. Refer to
"CONSULT Function (TIRE
PRESSURE MONITORING
SYSTEM)"
.
Hazard warning
lamp
The hazard warn-
ing lamp does not
blink twice when
performing ID reg-
istration operation.
—
ID registration is not
completed.
Perform “TIRE PRESSURE
SENSOR ID REGISTRA-
TION CANNOT BE COM-
PLETED” diagnosis
procedure. Refer to
.
SEIA0592E
SEIA0598E
SEIA0788E
LOW TIRE PRESSURE WARNING LAMP DOES NOT TURN ON
WT-49
< SYMPTOM DIAGNOSIS >
[WITH TPMS]
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
LOW TIRE PRESSURE WARNING LAMP DOES NOT TURN ON
Description
INFOID:0000000010339553
The low tire pressure warning lamp does not turn ON when the ignition switch is turned ON.
NOTE:
The low tire pressure warning lamp turn ON for approximately 1 second and then turns OFF when the ignition
switch is turned ON. This is to check that no abnormal condition is present in the tire pressure monitoring sys-
tem.
The combination meter may be malfunctioning or the tire pressure monitoring system may be malfunctioning if
the low tire pressure warning lamp does not turn ON when the ignition switch is turned ON.
Diagnosis Procedure
INFOID:0000000010339554
1.
CHECK LOW TIRE PRESSURE WARNING LAMP SIGNAL
With CONSULT
1.
Turn the ignition switch ON.
CAUTION:
Never start the engine.
2.
Select “ACTIVE TEST” in “AIR PRESSURE MONITOR”.
3.
Touch “WARNING LAMP” to turn ON the low tire pressure warning lamp.
When “ACTIVE TEST” is performed, does the low tire pressure warning lamp in the combination meter turn
ON?
YES
>> GO TO 2.
NO
>> GO TO 3.
2.
CHECK LOW TIRE PRESSURE WARNING LAMP OPERATION
Check that the low tire pressure warning lamp is turned OFF after turns ON for approximately 1 second, when
the ignition switch is turned ON.
Is the inspection result normal?
YES
>> Check intermittent incident. Refer to
GI-41, "Intermittent Incident"
.
NO
>> Replace the BCM. Refer to
BCS-132, "Removal and Installation"
.
3.
CHECK COMBINATION METER POWER SUPPLY CIRCUIT
Perform the trouble diagnosis for combination meter power supply circuit. Refer to
Is the inspection result normal?
YES
>> Perform combination diagnosis. Refer to
.
NO
>> Repair or replace error-detected parts.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст