Nissan Qashqai J11. Manual — part 876
WT-50
< SYMPTOM DIAGNOSIS >
[WITH TPMS]
LOW TIRE PRESSURE WARNING LAMP DOES NOT TURN OFF
LOW TIRE PRESSURE WARNING LAMP DOES NOT TURN OFF
Description
INFOID:0000000010339555
The low tire pressure warning lamp does not turn OFF after several seconds is passed after engine starts.
Diagnosis Procedure
INFOID:0000000010339556
1.
CHECK TIRE PRESSURE
1.
Turn the ignition switch ON.
CAUTION:
Never start the engine.
2.
Check the tire pressure for all wheels and adjust to the specified value. Refer to
.
3.
Perform TPMS temperature calibration. Refer to
WT-14, "TPMS temperature calibration"
.
4.
Recheck the tire pressure for all wheels. Refer to
.
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Inspect or repair the tires or wheels.
2.
CHECK LOW TIRE PRESSURE WARNING LAMP OPERATION
Check that the low tire pressure warning lamp is turned OFF after turns ON for approximately 1 second, when
the ignition switch is turned ON.
Is the inspection result normal?
YES
>> INSPECTION END
NO
>> GO TO 3.
3.
PERFORM SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis for “AIR PRESSURE MONITOR”.
Is DTC detected?
YES
>> Perform DTC diagnosis procedure. Refer to
NO
>> GO TO 4.
4.
CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for power supply and ground circuit. Refer to
BCS-125, "Diagnosis Procedure"
.
Is the inspection result normal?
YES
>> Replace BCM. Refer to
BCS-132, "Removal and Installation"
.
NO
>> Repair or replace error-detected parts.
LOW TIRE PRESSURE WARNING LAMP BLINKS
WT-51
< SYMPTOM DIAGNOSIS >
[WITH TPMS]
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
LOW TIRE PRESSURE WARNING LAMP BLINKS
Description
INFOID:0000000010339557
When the ignition switch is turned ON, the low tire pressure warning lamp blinks. And then 1 minute later, low
tire pressure warning lamp turns ON.
Diagnosis Procedure
INFOID:0000000010339558
1.
CHECK TIRE PRESSURE SENSOR INSTALLATION
Check visually that tire pressure sensors are installed to each wheels correctly.
NOTE:
In the following case, tire pressure monitoring system (TPMS) does not function.
• Tire pressure sensor(s) are not installed.
• Tire pressure sensor(s) of other cars are installed.
Are the genuine NISSAN tire pressure sensors are installed correctly?
YES
>> GO TO 2.
NO
>> Replace and/or Install tire pressure sensor(s). Refer to
WT-62, "Removal and Installation"
. GO TO
3.
2.
PERFORM SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis for “AIR PRESSURE MONITOR”.
Is DTC detected?
YES
>> Perform DTC diagnosis procedure. Refer to
NO
>> GO TO 4.
3.
TIRE PRESSURE SENSOR ID REGISTRATION
Perform tire pressure sensor ID registration. Refer to
.
Is tire pressure sensor ID registration completed?
YES
>> Adjust the tire pressure for all wheels specified to the value. Refer to
.
And perform TPMS temperature calibration. Refer to
WT-14, "TPMS temperature calibration"
.
INSPECTION END
NO
>> Perform diagnosis procedure of “TIRE PRESSURE SENSOR ID REGISTRATION CANNOT BE
.
4.
CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for power supply and ground circuit. Refer to
BCS-125, "Diagnosis Procedure"
.
Is the inspection result normal?
YES
>> Replace BCM. Refer to
BCS-132, "Removal and Installation"
.
NO
>> Repair or replace error-detected parts.
WT-52
< SYMPTOM DIAGNOSIS >
[WITH TPMS]
LOW TIRE PRESSURE LOCATION INDICATOR DOES NOT DISPLAY
LOW TIRE PRESSURE LOCATION INDICATOR DOES NOT DISPLAY
Description
INFOID:0000000010339559
When low tire pressure, low tire location indicator does not display though low tire pressure warning lamp
turns ON.
Diagnosis Procedure
INFOID:0000000010339560
1.
CHECK COMBINATION METER
Check combination meter. Refer to
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair or replace error-detected parts.
2.
CHECK LOW TIRE PRESSURE WHELL LOCATION INDICATOR OPERATION
Check that the low tire pressure location indicator is turned OFF after turns ON for approximately 1 second,
when the ignition switch is turned ON.
Is the inspection result normal?
YES
>> Check intermittent incident. Refer to
GI-41, "Intermittent Incident"
.
NO
LOW TIRE PRESSURE LOCATION INDICATOR CONTINUES DISPLAYING
WT-53
< SYMPTOM DIAGNOSIS >
[WITH TPMS]
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
LOW TIRE PRESSURE LOCATION INDICATOR CONTINUES DISPLAYING
Description
INFOID:0000000010339561
The low tire pressure location indicator continues displaying though low tire pressure warning lamp turns/stays
OFF.
Diagnosis Procedure
INFOID:0000000010339562
1.
CHECK TIRE PRESSURE
1.
Turn the ignition switch ON.
CAUTION:
Never start the engine.
2.
Check the tire pressure for all wheels and adjust to the specified value. Refer to
.
3.
Perform TPMS temperature calibration. Refer to
WT-14, "TPMS temperature calibration"
.
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Inspect or repair the tires or wheels.
2.
CHECK LOW TIRE PRESSURE LOCATION INDICATOR
Check low tire pressure location indicator.
Does low tire pressure location indicator continues displaying?
YES
>> GO TO 3.
NO
>> INSPECTION END
3.
PERFORM SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis for “AIR PRESSURE MONITOR”.
Is DTC detected?
YES
>> Perform DTC diagnosis procedure. Refer to
NO
>> GO TO 4.
4.
CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for power supply and ground circuit. Refer to
BCS-125, "Diagnosis Procedure"
.
Is the inspection result normal?
YES
>> Replace BCM. Refer to
BCS-132, "Removal and Installation"
.
NO
>> Repair or replace error-detected parts.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст