Nissan Qashqai J11. Manual — part 631
TRANSAXLE ASSEMBLY
TM-99
< UNIT DISASSEMBLY AND ASSEMBLY >
[6MT: RS6F95R]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
12. Remove the selector shaft (1) from the mechanism housing.
13. Remove the control lever shaft seal (1) using a screwdriver.
14. Remove the control lever shaft rings using a slide hammer (A)
with a diameter 16 mm (0.63 in).
15. Raise the spring (1) and rotate the control module (2) clockwise
until the claw (3) of the reverse gear shaft is freed from any
restriction.
E1DIA0310ZZ
E1DIA0311ZZ
E1DIA0312ZZ
E1DIA0273ZZ
TM-100
< UNIT DISASSEMBLY AND ASSEMBLY >
[6MT: RS6F95R]
TRANSAXLE ASSEMBLY
16. Engage reverse gear by pushing on the fork.
17. Put the part (1) of the selector shaft in the top position.
18. Pass the part (2) of the control module over the claw (1) of the
reverse gear shaft.
NOTE:
It is possible that the control module will attach to the claw of the 5-6 fork claw during the rotation. In this
case, pull gently upwards to allow it to pass.
19. Slightly raise forks 1-2, 3-4 and 5-6 and pivot the control module clockwise again until it stops on the claw
of fork 3-4.
20. Raise the control module to remove it from the clutch housing.
21.
NOTE:
This operation requires two people.
Remove the “input shaft - output shaft - shafts and forks” assem-
bly by raising the reverse gear intermediate pinions and shaft
slightly.
E1DIA0274ZZ
E1DIA0275ZZ
E1DIA0276ZZ
E1DIA0277ZZ
TRANSAXLE ASSEMBLY
TM-101
< UNIT DISASSEMBLY AND ASSEMBLY >
[6MT: RS6F95R]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
22. Remove the input shaft lip seal (1) using a screwdriver (A) .
CAUTION:
Never damage mechanism housing.
23. Remove the reverse gear “fork and shaft - pinions” assembly (1)
.
24. Remove:
• the permanent shim (1) ,
• the reverse gear sprocket (2),
• the synchroniser hub (3),
• the engagement clips (4),
• the needle bearing cage (5),
• the stop needle bearing cage (6),
• the synchroniser ring (7),
• the reverse gear sprocket (8),
• the needle bearing cage (9),
• the stop needle bearing cage (10),
• the pin (11) from the reverse gear shaft (12) .
25. Remove differential assembly (1).
26. Remove:
E1DIA0278ZZ
E1DIA0319ZZ
E1DIA0320ZZ
E1DIA0324ZZ
TM-102
< UNIT DISASSEMBLY AND ASSEMBLY >
[6MT: RS6F95R]
TRANSAXLE ASSEMBLY
• the bolts (1) of the differential crownwheel,
• the differential unit of the differential crownwheel.
27. Remove differential bearings using a separator (A).
28. Remove the differential bearing housing using a roll pin punch
(A).
29. Remove:
E1DIA0325ZZ
E1DIA0328ZZ
E1DIA0271ZZ
E1DIA0306ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст