Nissan Qashqai J11. Manual — part 567
FUEL TANK
FL-13
< REMOVAL AND INSTALLATION >
[HRA2DDT]
C
D
E
F
G
H
I
J
K
L
M
A
FL
N
P
O
2.
Start engine and rev it up and make sure there are no fuel leaks at the fuel system tube and hose connec-
tions.
FL-14
< SERVICE DATA AND SPECIFICATIONS (SDS)
[HRA2DDT]
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Fuel Tank
INFOID:0000000010418991
Standard and Limit
Fuel tank capacity
Approximate 55 (12-1/8 Imp gal)
Fuel recommendation
Refer to
PRECAUTIONS
FL-15
< PRECAUTION >
[MR20DD]
C
D
E
F
G
H
I
J
K
L
M
A
FL
N
P
O
PRECAUTION
PRECAUTIONS
General Precautions
INFOID:0000000010683781
WARNING:
When replacing fuel line parts, be sure to observe the following.
• Put a “CAUTION: FLAMMABLE” sign in the workshop.
• Be sure to work in a well ventilated area and furnish workshop with a CO
2
fire extinguisher.
• Never smoke while servicing fuel system. Keep open flames and sparks away from the work area.
CAUTION:
• Use gasoline required by the regulations for octane number. Refer to
.
• Before removing fuel line parts, perform out the following procedures:
- Put drained fuel in an explosion-proof container and put the lid on securely. Keep the container in
safe area.
- Release fuel pressure from the fuel lines. Refer to
.
- Disconnect the battery cable from the negative terminal.
• Always replace O-ring and clamps with new ones.
• Never kink or twist tubes when they are being installed.
• Never tighten hose clamps excessively to avoid damaging hoses.
• After installing tubes, check there is no fuel leakage at connections in the following steps.
- Apply fuel pressure to fuel lines with turning ignition switch “ON” (with engine stopped). Then check
for fuel leakage at connections.
- Start engine and rev it up and check for fuel leakage at connections.
• Use only a genuine NISSAN fuel filler cap as a replacement. If an incorrect fuel filler cap is used, the
“MI” may come on.
FL-16
< PREPARATION >
[MR20DD]
PREPARATION
PREPARATION
PREPARATION
Special Service Tools
INFOID:0000000010683799
Tool number
Tool name
Description
KV99104700
Lock ring wrench
Removing and installing lock ring
ZZA0122D
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст