Nissan Qashqai J11. Manual — part 587
EX-28
< REMOVAL AND INSTALLATION >
[R9M]
EXHAUST GAS TEMPERATURE SENSOR
• Install the exhaust gas temperature sensor on the exhaust gas cooler on the workbench using the tool [SST:
— (Mot.1807)] and the tool [SST: — (Ms.1973)].
• Note the following, and install in the reverse order of removal.
CAUTION:
• Before installing a new exhaust gas temperature sensor, clean exhaust gas cooler thread.
• Be careful not to impact or damage exhaust gas temperature sensor.
• When installing, never use such tools as an air impact wrench
EXHAUST GAS PRESSURE SENSOR
EX-29
< REMOVAL AND INSTALLATION >
[R9M]
C
D
E
F
G
H
I
J
K
L
M
A
EX
N
P
O
EXHAUST GAS PRESSURE SENSOR
Removal and installation
INFOID:0000000010287100
REMOVAL
1.
Disconnect the batterie negative terminal.
2.
Remove cowl top cover and extension cowl top. Refer to
3.
Remove the oxygen sensor. Refer to
4.
Disconnect the exhaust gas pressure sensor connector.
5.
Remove:
-
the bolt (1) from the exhaust gas pressure sensor bracket.
-
the clip (2) between the exhaust gas pressure sensor hose and
take-off pipe.
6.
Remove the exhaust gas pressure sensor and hose assembly.
7.
Remove the exhaust gas pressure sensor clamp. Refer to
8.
Separate the exhaust gas pressure sensor from hose. Refer to
9.
Separate the exhaust gas pressure sensor from bracket.
INSTALLATION
• Note the following, and install in the reverse order of removal.
NOTE:
Always replace the clamp between the exhaust gas pressure sensor hose and the take-off pipe.
E1BIA0623ZZ
EX-30
< REMOVAL AND INSTALLATION >
[R9M]
PARTICLE FILTER PRESSURE SENSOR
PARTICLE FILTER PRESSURE SENSOR
Removal and installation
INFOID:0000000010287101
REMOVAL
1.
Disconnect the batterie negative terminal.
2.
Remove cowl top cover and extension cowl top. Refer to
3.
Remove the air inlet pipe
4.
Remove the air duct inlet.
5.
Disconnect the turbocharging pressure regulation vacumm hose
from turbocharger (1).
6.
Unclip the turbocharging pressure regulation vacumm hose (2)
7.
Remove the turbocharging pressure regulation solenoide valve
nuts (1)
8.
Move aside the turbocharging pressure regulation solenoide
valve
9.
Remove the turbocharging pressure regulation solenoide valve
bracket bolts (1)
10. Remove the turbocharging pressure regulation solenoide valve
bracket.
11. Disconnect the particle filter sensor (1), (2) and (3).
12. Remove the particle sensor connector bracket.
E1BIA0625ZZ
E1BIA0626ZZ
E1BIA0627ZZ
E1BIA0628ZZ
PARTICLE FILTER PRESSURE SENSOR
EX-31
< REMOVAL AND INSTALLATION >
[R9M]
C
D
E
F
G
H
I
J
K
L
M
A
EX
N
P
O
13. Remove the particle filter. Refer to
EX-24, "Removal and installation"
14. Remove the particle filter pressure sensor from the Particle filter on the workbench Refer to
INSTALLATION
• Note the following, and install in the reverse order of removal.
CAUTION:
• Before installing particle filter pressure sensor, clean particle filter thread.
• Be careful not to impact or damage particle filter pressure sensor.
• When installing never use such tools as an air impact wrench.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст