Nissan Maxima. Manual — part 600
EXL-142
< SYMPTOM DIAGNOSIS >
[XENON TYPE]
NORMAL OPERATING CONDITION
NORMAL OPERATING CONDITION
Description
INFOID:0000000010050256
XENON HEADLAMP
• The brightness and color of the light may vary slightly immediately after turning the headlamp ON. This con-
dition will remain until the xenon bulb becomes stable. This is normal.
• Illumination time lag may occur between right and left. This is normal.
AUTO LIGHT SYSTEM
The auto light system may not turn the headlamp ON/OFF immediately after passing a dark area or a bright
area (short tunnel, sky bridge, shadowed area etc.). This is normal.
BOTH SIDE HEADLAMPS DO NOT SWITCH TO HIGH BEAM
EXL-143
< SYMPTOM DIAGNOSIS >
[XENON TYPE]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
BOTH SIDE HEADLAMPS DO NOT SWITCH TO HIGH BEAM
Description
INFOID:0000000010050257
The headlamps (both sides) do not switch to high beam when the lighting switch is in the HI or PASS setting.
Diagnosis Procedure
INFOID:0000000010050258
1.
COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) INSPECTION
Check the combination switch (lighting and turn signal switch). Refer to
.
Is the combination switch (lighting and turn signal switch) normal?
YES
>> GO TO 2.
NO
>> Repair or replace the malfunctioning part.
2.
CHECK HEADLAMP (HI) REQUEST SIGNAL INPUT
CONSULT DATA MONITOR
1. Select "HL HI REQ" of IPDM E/R DATA MONITOR item.
2. While operating the lighting switch, check the monitor status.
Is the item status normal?
YES
>> GO TO 3.
NO
>> Replace BCM. Refer to
BCS-79, "Removal and Installation"
3.
HEADLAMP (HI) CIRCUIT INSPECTION
Check the headlamp (HI) circuit. Refer to
Is the headlamp (HI) circuit normal?
YES
>> Replace IPDM E/R. Refer to
PCS-35, "Removal and Installation"
.
NO
>> Repair or replace the malfunctioning part.
Monitor item
Condition
Monitor status
HL HI REQ
Lighting switch
(2ND)
HI or PASS
ON
Except for HI or PASS
OFF
EXL-144
< SYMPTOM DIAGNOSIS >
[XENON TYPE]
BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON
BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON
Description
INFOID:0000000010050259
The headlamps (both sides) do not turn ON in any lighting switch setting.
Diagnosis Procedure
INFOID:0000000010050260
1.
CHECK COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH)
Check the combination switch (lighting and turn signal switch). Refer to
.
Is the combination switch (lighting and turn signal switch) normal?
YES
>> GO TO 2.
NO
>> Repair or replace the malfunctioning part.
2.
CHECK HEADLAMP (LO) REQUEST SIGNAL INPUT
CONSULT DATA MONITOR
1. Select "HL LO REQ" of IPDM E/R DATA MONITOR item.
2. While operating the lighting switch, check the monitor status.
Is the item status normal?
YES
>> GO TO 3.
NO
>> Replace BCM. Refer to
BCS-79, "Removal and Installation"
3.
HEADLAMP (LO) CIRCUIT INSPECTION
Check the headlamp (LO) circuit. Refer to
.
Is the headlamp (LO) circuit normal?
YES
>> Replace IPDM E/R. Refer to
PCS-35, "Removal and Installation"
NO
>> Repair or replace the malfunctioning part.
Monitor item
Condition
Monitor status
HL LO REQ
Lighting switch
2ND
ON
OFF
OFF
PARKING, LICENSE PLATE AND TAIL LAMPS ARE NOT TURNED ON
EXL-145
< SYMPTOM DIAGNOSIS >
[XENON TYPE]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
PARKING, LICENSE PLATE AND TAIL LAMPS ARE NOT TURNED ON
Description
INFOID:0000000010050261
The parking, license plate and tail lamps do not turn ON in with any lighting switch setting.
Diagnosis Procedure
INFOID:0000000010050262
1.
COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) INSPECTION
Check the combination switch (lighting and turn signal switch). Refer to
.
Is the combination switch (lighting and turn signal switch) normal?
YES
>> GO TO 2.
NO
>> Repair or replace the malfunctioning part.
2.
CHECK TAIL LAMP RELAY REQUEST SIGNAL INPUT
CONSULT DATA MONITOR
1. Select "TAIL & CLR REQ" of IPDM E/R DATA MONITOR item.
2. While operating the lighting switch, check the monitor status.
Is the item status normal?
YES
>> GO TO 3.
NO
>> Replace BCM. Refer to
BCS-79, "Removal and Installation"
3.
PARK LAMP CIRCUIT INSPECTION
Check the parking lamp circuit. Refer to
.
Is the tail lamp circuit normal?
YES
>> Replace IPDM E/R. Refer to
PCS-35, "Removal and Installation"
.
NO
>> Repair or replace the malfunctioning part.
Monitor item
Condition
Monitor status
TAIL & CLR REQ
Lighting switch
1ST
ON
OFF
OFF
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст