Nissan Maxima. Manual — part 127
AV-328
< REMOVAL AND INSTALLATION >
[COLOR DISPLAY - W/O BOSE]
AUDIO ANTENNA
2. If an element is broken, no continuity will exist.
3. To locate a break, move probe along element. Tester indication
will change abruptly when probe passes the broken point.
REPAIR EQUIPMENT
• Conductive silver composition (DuPont No. 4817 or equivalent)
• Ruler 30 cm (11.8 in) long
• Drawing pen
• Heat gun
• Alcohol
• Cloth
REPAIRING PROCEDURE
1. Wipe broken heat wire and its surrounding area clean with a
cloth dampened in alcohol.
2. Apply a small amount of conductive silver composition to tip of
drawing pen.
NOTE:
Shake silver composition container before use.
3. Place ruler on glass along broken line. Deposit conductive silver
composition on break with drawing pen. Slightly overlap existing
heat wire on both sides [preferably 5 mm (0.20 in)] of the break.
SEL252I
SEL253I
PIIA0215E
AV
AUDIO ANTENNA
AV-329
< REMOVAL AND INSTALLATION >
[COLOR DISPLAY - W/O BOSE]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
4. After repair has been completed, check repaired wire for conti-
nuity. This check should be conducted 10 minutes after silver
composition is deposited.
Do not touch repaired area while test is being conducted.
5. Apply a constant stream of hot air directly to the repaired area
for approximately 20 minutes with a heat gun. A minimum dis-
tance of 3 cm (1.2 in) should be kept between repaired area and
hot air outlet.
If a heat gun is not available, let the repaired area dry for 24
hours.
SEL012D
SEL013D
AV-330
< REMOVAL AND INSTALLATION >
[COLOR DISPLAY - W/O BOSE]
ANTENNA AMP.
ANTENNA AMP.
Removal and Installation
INFOID:0000000010064944
REMOVAL
1. Remove the rear pillar finisher RH. Refer to
2. Detach the antenna amp. harness clip (A).
3. Disconnect the harness connectors (B) from the antenna amp.
(1).
4. Remove the antenna amp. screw (C) and the antenna amp. (1).
INSTALLATION
Installation is in the reverse order of removal.
ALNIA0043ZZ
AV
MICROPHONE
AV-331
< REMOVAL AND INSTALLATION >
[COLOR DISPLAY - W/O BOSE]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
MICROPHONE
Removal and Installation
INFOID:0000000010064945
REMOVAL
1. Remove the map lamp assembly. Refer to
INL-84, "Removal and Installation"
.
2. Detach the microphone connector (A).
3. Remove the map lamp covers (1), then remove the map lamp
assembly cover (2).
4. Release the microphone tabs (A), then remove the microphone
(1).
INSTALLATION
Installation is in the reverse order of removal.
ALNIA0928ZZ
ALNIA0929ZZ
ALNIA0930ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст