Nissan Leaf. Manual — part 676
FLOOR SIDE FAIRING
EXT-23
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
FLOOR SIDE FAIRING
FRONT UNDER COVER
FRONT UNDER COVER : Exploded View
INFOID:0000000010119994
FRONT UNDER COVER : Removal and Installation
INFOID:0000000010119995
REMOVAL
1. Remove front under cover front mounting bolts.
2. Remove front under cover fixing clips and then remove front under cover.
INSTALLATION
Install in the reverse order of removal.
REAR DIFFUSER
REAR DIFFUSER : Exploded View
INFOID:0000000010119996
1.
Front under cover
: Vehicle front
JMKIA6448ZZ
JMKIA6449ZZ
EXT-24
< REMOVAL AND INSTALLATION >
FLOOR SIDE FAIRING
REAR DIFFUSER : Removal and Installation
INFOID:0000000010119997
REMOVAL
1. Remove rear diffuser mounting bolts, clips and nut.
2. Remove rear diffuser.
INSTALLATION
Install in the reverse order of removal.
1.
Rear diffuser
: Vehicle front
ROOF SIDE MOLDING
EXT-25
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
ROOF SIDE MOLDING
Exploded View
INFOID:0000000010119998
1.
Roof side molding
2.
Roof side molding clip
3.
Rivet
4.
Molding fastener
5.
Body side outer panel
6.
Roof panel
7.
Paint seal
ALKIA3125ZZ
EXT-26
< REMOVAL AND INSTALLATION >
ROOF SIDE MOLDING
Removal and Installation
INFOID:0000000010119999
REMOVAL
1. Remove front fender cover (LH and RH). Refer to
2. Disengage roof side molding fixing clips form front end.
CAUTION:
Never pull the roof side molding strongly to prevent dam-
age to the parts.
3. Twist roof side molding toward vehicle outside, lift it up and
remove it while disengaging clips.
CAUTION:
Never pull the roof side molding strongly to prevent dam-
age to the parts.
INSTALLATION
Note the following item, and then install in the reverse order of removal.
CAUTION:
Install spacer roof molding between rear end of roof molding fixing clips.
REMOVAL AND INSTALLATION OF ROOF SIDE MOLDING CLIP
Removal
1. Remove roof side molding.
2. Heat adhesive tape interface using a dryer, and then peel roof side molding clips (body side) using long-
nose pliers.
CAUTION:
Be careful not to damage the body.
Installation
1. Clean tape removed surface with a shop cloth soaked in white gasoline or IPA.
2. Use two-part epoxy adhesive.
3. Apply adhesive evenly to clip tape surface.
4. Position applied parts to the proper location, and then sufficiently press-fit until the adhesive protrudes to
tape side.
: Clip
: Always replace after every disassembly.
: Clip
JMKIA7740ZZ
: Clip
JMKIA7741ZZ
Adhesive
: 3M-weld DP–100 or equivalent
Thickness
: Approximately 0.5 mm (0.020 in)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст