Nissan Leaf. Manual — part 719
GW-24
< REMOVAL AND INSTALLATION >
REAR DOOR GLASS
7. Operate the power window switch to lower the rear door glass.
8. Remove rear door glass run from partition sash.
9. Pull partition sash (1) out of the rear door panel to remove, as
shown in the figure.
10. Remove rear door glass from the rear door panel, as shown in
the figure.
11. Remove partition glass.
a. Slide partition glass toward the direction of arrow 1.
b. Pull partition glass toward the direction of arrow 2 to remove.
INSTALLATION
Installation is in the reverse order of removal.
Inspection and Adjustment
INFOID:0000000010119169
FITTING INSPECTION
• Check that the glass is fit securely into the sash groove.
• Lower the glass slightly [approximately 10 to 20 mm (0.394 to 0.787 in)], and check that the clearance to the
sash is parallel. If the clearance between the glass and sash is not parallel, loosen the regulator bolts, guide
rail bolts and glass bolts to correct the glass position.
JMKIA6428ZZ
JMKIA6429ZZ
JMKIA6430ZZ
REAR REGULATOR
GW-25
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
GW
N
O
P
REAR REGULATOR
Exploded View
INFOID:0000000010119170
Removal and Installation
INFOID:0000000010119171
REMOVAL
1. Remove rear door glass. Refer to
GW-23, "Removal and Installation"
.
2. Disconnect the power window motor harness connector.
1.
Rear door panel
2.
Rear door glass run
3.
Sealing screen
4.
Rear door regulator
5.
Power window motor
6.
Partition glass
7.
Partition sash
8.
Rear door glass
Front
JMKIA6426ZZ
GW-26
< REMOVAL AND INSTALLATION >
REAR REGULATOR
3. Remove the rear door regulator assembly bolts and nuts, then
remove rear door regulator assembly from door panel, as shown
in the figure.
INSTALLATION
Installation is in the reverse order of removal.
Disassembly and Assembly
INFOID:0000000010119172
DISASSEMBLY
Remove the power window motor from the rear door regulator.
INSPECTION AFTER REMOVAL
Check the rear door regulator assembly for the following items. Replace or grease it if a malfunction is
detected.
• Wire wear
• Regulator deformation
ASSEMBLY
Assembly is in the reverse order of disassembly.
Inspection and Adjustment
INFOID:0000000010119173
Inspection after removal
Check the rear regulator assembly for the following items. Replace or grease it if a malfunction is detected.
• Wire wear
• Rear regulator deformation
• Grease condition for each sliding part
FITTING INSPECTION
• Check that the glass is fit securely into the sash groove.
• Lower the glass slightly [approximately 10 to 20 mm (0.394 to 0.787 in)], and check that the clearance to the
sash is parallel. If the clearance between the glass and sash is not parallel, loosen the regulator bolts, guide
rail bolts and glass bolts to correct the glass position.
JMKIA6431ZZ
HA-1
VENTILATION, HEATER & AIR CONDITIONER
C
D
E
F
G
H
J
K
L
M
SECTION
HA
A
B
HA
N
O
P
CONTENTS
HEATER & AIR CONDITIONING SYSTEM
WITH HEAT PUMP SYSTEM
PRECAUTION . . . . . . . . . . . ...
PRECAUTIONS . . . . . . . . . . . . ...
Precaution for Technicians Using Medical Electric
. ..
Point to Be Checked Before Starting Maintenance
Work . . . . . . . . . . . . . . . . . . ..
Precaution for Procedure without Cowl Top Cover . ..
High Voltage Precautions . . . . . . . . . . ..
Precaution for Removing 12V Battery . . . . . ...
Precautions for Service Work of Cooler System . ...
Service Equipment . . . . . . . . . . . . ..
PREPARATION . . . . . . . . . . ...
PREPARATION . . . . . . . . . . . . ..
Commercial Service Tools . . . . . . . . . ..
Oil and Grease . . . . . . . . . . . . . .
SYSTEM DESCRIPTION . . . . . . . .
COMPONENT PARTS . . . . . . . . . ...
REFRIGERATION SYSTEM . . . . . . . . . ..
REFRIGERATION SYSTEM : Component Parts
Location . . . . . . . . . . . . . . . . ...
HEATING AND COOLING UNIT ASSEMBLY . . ..
HEATING AND COOLING UNIT ASSEMBLY :
Heating and Cooling Unit . . . . . . . . . .
HEATING AND COOLING UNIT ASSEMBLY :
Evaporator . . . . . . . . . . . . . . . ...
HEATING AND COOLING UNIT ASSEMBLY : In-
ner condenser . . . . . . . . . . . . . . .
Condenser . . . . . . . . . . . . . . . ...
Electric Compressor . . . . . . . . . . . .
Orifice . . . . . . . . . . . . . . . . . ..
Accumulator . . . . . . . . . . . . . . .
Refrigerant and Compressor Oil . . . . . . . ..
High Voltage Warning Label . . . . . . . . .
SYSTEM . . . . . . . . . . . . . . .
REFRIGERATION SYSTEM . . . . . . . . . ..
REFRIGERATION SYSTEM : System Diagram . ..
REFRIGERATION SYSTEM : System Description
HEATING SYSTEM . . . . . . . . . . . . .
HEATING SYSTEM : System Diagram . . . . ...
HEATING SYSTEM : System Description . . . ...
BASIC INSPECTION . . . . . . . . ...
DIAGNOSIS AND REPAIR WORK FLOW . ...
Workflow . . . . . . . . . . . . . . . . ..
REFRIGERANT . . . . . . . . . . . . .
Description . . . . . . . . . . . . . . . ...
Check Refrigerant Leakage . . . . . . . . . .
Recycle Refrigerant . . . . . . . . . . . . .
Charge Refrigerant . . . . . . . . . . . . ..
LUBRICANT . . . . . . . . . . . . . ..
Description . . . . . . . . . . . . . . . ...
Inspection . . . . . . . . . . . . . . . .
Perform Lubricant Return Operation . . . . . ...
Lubricant Adjusting Procedure for Components
Replacement Except Compressor . . . . . . ...
Lubricant Adjusting Procedure for Compressor
Replacement . . . . . . . . . . . . . . ...
PERFORMANCE TEST . . . . . . . . .
Inspection . . . . . . . . . . . . . . . .
SYMPTOM DIAGNOSIS . . . . . . . ..
REFRIGERATION SYSTEM SYMPTOMS . .
Trouble Diagnosis For Unusual Pressure . . . .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст