Nissan Murano. Manual — part 453
TRANSFER OIL
DLN-51
< PERIODIC MAINTENANCE >
[TRANSFER: TY20A]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
PERIODIC MAINTENANCE
TRANSFER OIL
Inspection
INFOID:0000000009718137
OIL LEAKAGE
Check transfer surrounding area (oil seal, drain plug, filler plug, and transfer case, etc.) for oil leakage.
OIL LEVEL
1.
Remove filler plug (1) and gasket. Then check that oil is filled up
(A) from mounting hole for the filler plug.
2.
Before installing filler plug, set a new gasket. Install filler plug on
transfer and tighten to the specified torque. Refer to
CAUTION:
Never reuse gaskets.
Draining
INFOID:0000000009718138
1.
Run the vehicle to warm up the transfer unit sufficiently.
2.
Stop the engine and remove drain plug (1) and gaskets to drain
the transfer oil.
3.
Before installing drain plug, set a new gasket. Install drain plug
on transfer and tighten to the specified torque. Refer to
CAUTION:
Never reuse gaskets.
Refilling
INFOID:0000000009718139
1.
Remove filler plug (1) and gasket. Then fill oil up to mounting
hole (A) for the filler plug.
CAUTION:
Carefully fill the oil. (Fill up for approximately 3 minutes.)
2.
Leave the vehicle for 3 minutes. Then check oil level again.
3.
Before installing filler plug, set a new gasket. Install filler plug on transfer and tighten to the specified
torque. Refer to
: Vehicle front
JPDIE0017ZZ
: Vehicle front
JPDIE0016ZZ
: Vehicle front
Oil grade and viscosity
: Refer to
NORTH AMERICA : Fluids
and Lubricants"
(for
"FOR MEXICO : Fluids and
Lubricants"
(for MEXICO).
Oil capacity
: Refer to
.
JPDIE0017ZZ
DLN-52
< PERIODIC MAINTENANCE >
[TRANSFER: TY20A]
TRANSFER OIL
CAUTION:
Never reuse gasket.
AWD CONTROL UNIT
DLN-53
< REMOVAL AND INSTALLATION >
[TRANSFER: TY20A]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
REMOVAL AND INSTALLATION
AWD CONTROL UNIT
Exploded View
INFOID:0000000009718140
Removal and Installation
INFOID:0000000009718141
REMOVAL
1.
Remove instrument lower panel LH. Refer to
2.
Remove Knee protector (1).
3.
Disconnect AWD control unit harness connector.
4.
Remove AWD control unit mounting bolts.
5.
Remove AWD control unit (1).
INSTALLATION
1.
AWD control unit
: Vehicle front
JPDIE0051ZZ
: Bolt
JSGIA0306ZZ
JPDIE0054ZZ
DLN-54
< REMOVAL AND INSTALLATION >
[TRANSFER: TY20A]
AWD CONTROL UNIT
Install in the reverse order of removal.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст