Nissan Terrano model r20 series 2004. Manual — part 253
c. While holding anchor end pin, tighten lock nut.
8. Install terminal cord assembly.
a. Install O-ring on terminal cord assembly.
I
Apply petroleum jelly to O-ring.
b. Compress terminal cord assembly stopper and install terminal
cord assembly on transmission case.
9. Install control valve assembly.
a. Install accumulator piston return springs
q
B
,
q
C
and
q
D
.
Free length of return springs:
Refer to SDS, AT-202.
b. Install manual valve on control valve.
I
Apply ATF to manual valve.
c. Place control valve assembly on transmission case. Connect
solenoid connector for upper body.
d. Install connector clip.
SAT002B
SAT115B
SAT004BA
SAT005B
SAT006B
ASSEMBLY
Assembly (2) (Cont’d)
AT-196
e. Install control valve assembly on transmission case.
f.
Install connector tube brackets and tighten bolts
q
A
and
q
B
.
I
Check that terminal assembly does not catch.
Bolt symbol
mm (in)
q
A
33 (1.30)
q
B
45 (1.77)
g. Install O-ring on oil strainer.
I
Apply petroleum jelly to O-ring.
h. Install oil strainer on control valve.
i.
Securely fasten terminal harness with clips.
j.
Install torque converter clutch solenoid valve and fluid tempera-
ture sensor connectors.
SAT353B
SAT221B
SAT009B
SAT010B
ASSEMBLY
Assembly (2) (Cont’d)
AT-197
10. Install oil pan.
a. Attach a magnet to oil pan.
b. Install new oil pan gasket on transmission case.
c. Install oil pan and bracket on transmission case.
I
Always replace oil pan bolts as they are self-sealing bolts.
I
Before installing bolts, remove traces of sealant and oil
from mating surface and thread holes.
I
Tighten four bolts in a criss-cross pattern to prevent dis-
location of gasket.
d. Tighten drain plug.
11. Install park/neutral position switch.
a. Check that manual shaft is in “1” position.
b. Temporarily install park/neutral position switch on manual shaft.
c. Move manual shaft to “N”.
d. Tighten bolts while inserting 4.0 mm (0.157 in) dia. pin vertically
into locating holes in park/neutral position switch and manual
shaft.
12. Install torque converter.
a. Pour ATF into torque converter.
I
Approximately 2 liters (1-3/4 Imp qt) of fluid are required for
a new torque converter.
I
When reusing old torque converter, add the same amount
of fluid as was drained.
SAT011B
NAT291
NAT292
NAT290
SAT428DA
ASSEMBLY
Assembly (2) (Cont’d)
AT-198
b. Install torque converter while aligning notches and oil pump.
c. Measure distance A to check that torque converter is in proper
position.
Distance “A”:
26.0 mm (1.024 in) or more
SAT016B
SAT017B
ASSEMBLY
Assembly (2) (Cont’d)
AT-199
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст