Nissan Terrano model r20 series 2004. Manual — part 403
Installation
1. Prior to wiper arm installation, turn on wiper switch to operate
wiper motor and then turn it “OFF” (Auto Stop).
2. Lift the blade up and then set it down onto glass surface to set
the blade center to clearance “C” or “D” immediately before
tightening nut.
3. Eject washer fluid. Turn on wiper switch to operate wiper motor
and then turn it “OFF”.
4. Ensure that wiper blades stop within clearance “C” or “D”.
Clearance “C”: 25 - 35 mm (0.98 - 1.38 in)
Clearance “D”: 25 - 35 mm (0.98 - 1.38 in)
I
Tighten windshield wiper arm nuts to specified torque.
Front wiper:
: 20 - 30 N
⋅
m (2.1 - 3.0 kg-m, 15 - 22 ft-lb)
Rear wiper:
: 11.0 - 16.0 N
⋅
m
(1.12 - 1.63 kg-m, 8.1 - 11.8 ft-lb)
YEL077
NEL628
WIPER AND WASHER
EL-116
I
Before reinstalling wiper arm, clean up the pivot area as
illustrated. This will reduce possibility of wiper arm loose-
ness.
Washer Nozzle Adjustment
I
Adjust washer nozzle with suitable tool as shown in the figure
at left.
Adjustable range: ±10°
Check Valve
I
A check valve is provided in the washer fluid line. Be careful not
to connect check valve to washer tube in the wrong direction.
SEL024J
SEL241P
SEL411H
WIPER AND WASHER
Installation (Cont’d)
EL-117
Wiring Diagram — HLC —
LHD MODELS
YEL114D
WIPER AND WASHER
EL-118
LHD MODELS
YEL115D
WIPER AND WASHER
Wiring Diagram — HLC — (Cont’d)
EL-119
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст