Nissan Terrano model r20 series 2004. Manual — part 279
(1) When installing each rubber part, final tightening must be car-
ried out under unladen condition * with tires on ground.
* Fuel, radiator coolant and engine oil full. Spare tire, jack,
hand tools and mats in designated positions.
(2) When removing each suspension part, check wheel alignment
and adjust if necessary.
(3) Use Tool when removing or installing brake tubes.
SBR820B
PRECAUTIONS
FA-2
SPECIAL SERVICE TOOLS
*: Special tool or commercial equivalent
Tool number
Tool name
Description
ST29020001*
Gear arm puller
Removing ball joint for knuckle spindle
ST27850000
Ball joint remover
Removing tie-rod outer end
KV401021S0*
Bearing outer race
drift
q
1
ST35325000*
Drift bar
q
2
KV40102110*
Drift (A)
q
3
KV40102120*
Drift (B)
q
4
KV40102130*
Screw (A)
q
5
KV40102140*
Screw (B)
q
6
KV40102150*
Screw (C)
Installing wheel bearing outer race
KV40105400
Wheel bearing lock
nut wrench
Removing or installing wheel bearing lock nut
GG94310000*
Flare nut torque
wrench
Removing and installing brake piping
PREPARATION
FA-3
YFA003
FRONT AXLE AND FRONT SUSPENSION
FA-4
Front Axle and Front Suspension Parts
I
Check front axle and front suspension parts for looseness,
cracks, wear or other damage.
(1) Shake each front wheel.
(2) Make sure that cotter pin is inserted.
(3) Retighten all nuts and bolts to the specified torque.
: Refer to “FRONT SUSPENSION”, FA-29.
(4) Check front axle and front suspension parts for wear, cracks or
other damage.
I
Check shock absorber for oil leakage or other damage.
I
Check suspension ball joints for grease leakage and dust cov-
ers for cracks or other damage.
I
Check ball joint for vertical end play.
Upper ball joint:
1.6 mm (0.063 in) or less
(1) Jack up front of vehicle and set the stands.
(2) Clamp dial indicator onto transverse link and place indicator tip
on lower edge of brake caliper.
(3) Make sure front wheels are straight and brake pedal is
depressed.
(4) Place a pry bar between transverse link and inner rim of road
wheel.
(5) While pushing and releasing pry bar, observe maximum dial
indicator value.
(6) If ball joint movement is beyond specifications, remove and
recheck it.
SMA525A
SFA240
SMA241
SFA303A
CHECK AND ADJUSTMENT
FA-5
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст