Nissan Versa Sedan. Manual — part 497
MAGNET CLUTCH
HAC-43
< DTC/CIRCUIT DIAGNOSIS >
[MANUAL AIR CONDITIONING]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
Is the inspection result normal?
YES
>> Replace IPDM E/R. Refer to
PCS-56, "Removal and Installation"
.
NO
>> Repair harness or connector.
IPDM E/R
Compressor
Continuity
Connector
Terminal
Connector
Terminal
E45
28
F3
1
Yes
HAC-44
< SYMPTOM DIAGNOSIS >
[MANUAL AIR CONDITIONING]
MANUAL AIR CONDITIONING SYSTEM
SYMPTOM DIAGNOSIS
MANUAL AIR CONDITIONING SYSTEM
Symptom Table
INFOID:0000000009269808
SYMPTOM TABLE
Symptom
Reference Page
A/C system does not come on.
Go to Trouble Diagnosis Procedure for A/C System.
A/C system cannot be controlled.
Go to Self-diagnosis Function.
Air outlet does not change.
Go to Adjustment Procedure for Mode Door.
Discharge air temperature does not change.
Go to Adjustment Procedure for Air Mix Door.
Intake door does not change.
Go to Adjustment Procedure for Intake Door.
Front blower motor operation is malfunction-
ing.
Go to Trouble Diagnosis Procedure for Front Blower Motor.
Magnet clutch does not engage.
Go to Trouble Diagnosis Procedure for Magnet Clutch.
Insufficient cooling.
Go to Trouble Diagnosis Procedure for Insufficient Cooling.
Insufficient heating.
Go to Trouble Diagnosis Procedure for Insufficient Heating.
Noise.
Go to Trouble Diagnosis Procedure for Noise.
A/C switch LED does not illuminate.
Go to Trouble Diagnosis Procedure for A/C System.
Both high- and low-pressure sides are too
high.
Go to Trouble Diagnosis Procedure for Abnormal Pressure.
High-pressure side is too high and low pres-
sure side is too low.
Go to Trouble Diagnosis Procedure for Abnormal Pressure.
High-pressure side is too low and low-pres-
sure side is too high.
Go to Trouble Diagnosis Procedure for Abnormal Pressure.
Both high- and low-pressure side sometimes
become negative.
Go to Trouble Diagnosis Procedure for Abnormal Pressure.
Low-pressure side sometimes becomes neg-
ative.
Go to Trouble Diagnosis Procedure for Abnormal Pressure.
Low-pressure side becomes negative.
Go to Trouble Diagnosis Procedure for Abnormal Pressure.
INSUFFICIENT COOLING
HAC-45
< SYMPTOM DIAGNOSIS >
[MANUAL AIR CONDITIONING]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
INSUFFICIENT COOLING
Description
INFOID:0000000009269809
Symptom
• Insufficient cooling
• No cool air comes out. (Air flow volume is normal.)
Diagnosis Procedure
INFOID:0000000009269810
NOTE:
Perform self-diagnosis with CONSULT before performing symptom diagnosis. If any malfunction result or DTC
is detected, perform the corresponding diagnosis.
1.
CHECK MAGNET CLUTCH OPERATION
1. Turn ignition switch ON.
2. Turn fan control dial ON.
3. Press A/C switch.
4. Check that A/C indicator turns ON. Check visually and by sound that compressor operates.
5. Press A/C switch again.
6. Check that A/C indicator turns OFF. Check that compressor stops.
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Check compressor operation. Refer to
.
2.
CHECK DRIVE BELT
Check tension of drive belt. Refer to
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Adjust or replace drive belt depending on the inspection results.
3.
CHECK REFRIGERANT CYCLE PRESSURE
Connect the recovery/recycling recharging equipment to the vehicle and perform the pressure inspection
using gauge. Refer to
.
Is the inspection result normal?
YES
>> GO TO 4.
NO
>> Repair or replace parts depending on the inspection results.
4.
CHECK AIR LEAKAGE FROM EACH DUCT
Check duct and nozzle, etc. of the air conditioner system for leakage.
Is the inspection result normal?
YES
>> Check air mix door cable installation and air mix door operation.
NO
>> Repair or replace parts depending on the inspection results.
HAC-46
< SYMPTOM DIAGNOSIS >
[MANUAL AIR CONDITIONING]
INSUFFICIENT HEATING
INSUFFICIENT HEATING
Description
INFOID:0000000009269811
Symptom
• Insufficient heating
• No warm air comes out. (Air flow volume is normal.)
Diagnosis Procedure
INFOID:0000000009269812
NOTE:
Perform self-diagnosis with CONSULT before performing symptom diagnosis. If any malfunction result or DTC
is detected, perform the corresponding diagnosis.
1.
CHECK COOLING SYSTEM
1. Check engine coolant level and check for leakage. Refer to
2. Check radiator cap. Refer to
CO-12, "RADIATOR CAP : Inspection"
3. Check water flow sounds of the engine coolant. Refer to
CO-9, "Refilling Engine Coolant"
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Refill engine coolant and repair or replace the parts depending on the inspection results.
2.
CHECK HEATER HOSE
Check installation of heater hose by visually or touching.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Repair or replace parts depending on the inspection results.
3.
CHECK HEATER CORE
1. Check temperature of inlet hose and outlet hose of heater core.
2. Check that inlet side of heater core is hot and the outlet side is slightly lower than/almost equal to the inlet
side.
CAUTION:
Always perform the temperature inspection in a short period of time because the engine coolant
temperature is very hot.
Is the inspection result normal?
YES
>> GO TO 4.
NO
>> Replace heater core. Refer to
HA-39, "Removal and Installation"
4.
CHECK AIR LEAKAGE FROM EACH DUCT
Check duct and nozzle, etc. of air conditioning system for air leakage.
Is the inspection result normal?
YES
>> Check air mix door cable installation and air mix door operation.
NO
>> Repair or replace parts depending on the inspection results.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст