Nissan Primera P11. Manual — part 515

Shift Control Components

INSPECTION

I

Check contact surface and sliding surface for wear, scratches,
projections or other damage.

SMT703B

Striking rod

Control bracket

Shift fork and
shifter cap

SMT727B

REPAIR FOR COMPONENT PARTS

RS5F32A

Shift Control Components

MT-35

ADJUSTMENT OF INPUT SHAFT BRAKING
MECHANISM

1.

Install striking lever & rod, striking interlock assembly and con-
trol bracket on clutch housing exactly.

I

When installing control bracket on clutch housing, assure
protrusion beneath bracket is correctly seated.

2.

Measure maximum height “H” while shifting from neutral to
reverse position.

Maximum height “H”:

67.16 - 67.64 mm (2.6441 - 2.6630 in)

3.

Remove control bracket from clutch housing.

4.

Measure clearance “C” between reverse brake cam and strik-
ing lever at reverse position.

Clearance “C”:

0.05 - 0.125 mm (0.0020 - 0.0044 in)

5.

If height “H” and clearance “C” are not within specifications,
replace control bracket, striking lever and striking interlock
assembly as a set.

SMT774B

Control bracket

Clutch housing

SMT728B

1st & 2nd shifter

Height
gauge

1st & 2nd shifter

Striking lever

Control bracket
fitting surface

.

Reverse brake cam

SMT729B

Reverse brake cam

Striking lever

REPAIR FOR COMPONENT PARTS

RS5F32A

Shift Control Components (Cont’d)

MT-36

Case Components

REMOVAL AND INSTALLATION

Input shaft oil seal

I

Apply multi-purpose grease to seal lip of oil seal before
installing.

Input shaft rear bearing

1.

Remove welch plug from transmission case.

2.

Remove input shaft rear bearing by tapping it from welch plug
hole.

3.

Install welch plug.

I

Apply recommended sealant to mating surface of trans-
mission case.

SMT660A

Drift

SMT751BA

KV38102100

SMT705B

SMT704B

SMT705B

REPAIR FOR COMPONENT PARTS

RS5F32A

Case Components

MT-37

4.

Install input shaft rear bearing.

Mainshaft front bearing and oil channel

1.

Remove mainshaft front bearing retainer.

2.

Remove mainshaft front bearing.

3.

Remove oil channel.

4.

Install oil channel.

I

Ensure that oil groove in oil channel always faces toward
oil pocket when installing it on clutch housing.

5.

Install mainshaft front bearing.

6.

Install mainshaft front bearing retainer.

I

Apply locking sealant to thread of screw before installa-
tion.

SMT706B

SMT707B

Bearing
retainer

SMT714B

Mainshaft
front bearing

SMT595

Oil groove

Toward
oil pocket

SMT752BA

Drift

REPAIR FOR COMPONENT PARTS

RS5F32A

Case Components (Cont’d)

MT-38