Nissan Pathfinder. Manual — part 787
LAN
CAN GATEWAY SYSTEM
LAN-101
< WIRING DIAGRAM >
[CAN GATEWAY]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
WIRING DIAGRAM
CAN GATEWAY SYSTEM
Wiring Diagram
INFOID:0000000009174989
AAMWA0646GB
LAN-102
< WIRING DIAGRAM >
[CAN GATEWAY]
CAN GATEWAY SYSTEM
AAMIA1287GB
LAN
ADDITIONAL SERVICE WHEN REPLACING CAN GATEWAY
LAN-103
< BASIC INSPECTION >
[CAN GATEWAY]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
BASIC INSPECTION
ADDITIONAL SERVICE WHEN REPLACING CAN GATEWAY
Description
INFOID:0000000009174990
BEFORE REPLACEMENT
When replacing CAN gateway, save or print current vehicle specification with CONSULT configuration before
replacement.
NOTE:
If “Before Replace ECU” of “Read / Write Configuration” can not be used, use the “Manual Configuration” after
replacing CAN gateway.
AFTER REPLACEMENT
CAUTION:
Follow the instructions listed below. Failure to do this may cause malfunctions to the CAN gateway.:
• When replacing CAN gateway, you must perform “Read / Write Configuration” or “Manual Configura-
tion” with CONSULT.
• Complete the procedure of “Read / Write Configuration” or “Manual Configuration” in order.
• If you set incorrect “Read / Write Configuration” or “Manual Configuration”, incidents might occur.
• Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
• Never perform “Read / Write Configuration” or “Manual Configuration” except for new CAN gateway.
Work Procedure
INFOID:0000000009174991
1.
SAVING VEHICLE SPECIFICATION
CONSULT Configuration
Perform “Before Replace ECU” of “Read / Write Configuration” to save or print current vehicle specification.
NOTE:
If “Before Replace ECU” of “Read / Write Configuration” can not be used, use the “Manual Configuration” after
replacing CAN gateway.
>> GO TO 2.
2.
REPLACE CAN GATEWAY
Replace CAN gateway. Refer to
LAN-109, "Removal and Installation"
.
>> GO TO 3.
3.
WRITING VEHICLE SPECIFICATION
CONSULT Configuration
Perform “After Replace ECU” of “Read / Write Configuration” or “Manual Configuration” to write vehicle speci-
fication. Refer to
>> WORK END
LAN-104
< BASIC INSPECTION >
[CAN GATEWAY]
CONFIGURATION (CAN GATEWAY)
CONFIGURATION (CAN GATEWAY)
Work Procedure
INFOID:0000000009174992
1.
WRITING MODE SELECTION
CONSULT Configuration
Select “Re/programming, Configuration” of CAN gateway.
When writing saved data>>GO TO 2.
When writing manually>>GO TO 3.
2.
PERFORM “AFTER REPLACE ECU” OF “READ / WRITE CONFIGURATION”
CONSULT Configuration
Perform “After Replace ECU” of “Read / Write Configuration”.
>> GO TO 4.
3.
PERFORM “MANUAL CONFIGURATION”
CONSULT Configuration
1. Select “Manual Configuration”.
2. Touch “Next”.
3. Touch “OK”.
4. Check that the configuration has been successfully written and touch “End”.
>> GO TO 4.
4.
CHECK ALL ECU SELF-DIAGNOSIS RESULTS
1. Erase all ECU self-diagnosis results using CONSULT.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON and wait for 2 seconds or more.
4. Check that all ECU self-diagnosis results have no DTC (e.g. U1000 and U1001) of CAN communication.
>> WORK END
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст