Nissan Pathfinder. Manual — part 621
SQUEAK AND RATTLE TROUBLE DIAGNOSES
EXT-15
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
LAIA0071E
EXT-16
< REMOVAL AND INSTALLATION >
FRONT BUMPER
REMOVAL AND INSTALLATION
FRONT BUMPER
Exploded View
INFOID:0000000009176334
AWKIA2642ZZ
FRONT BUMPER
EXT-17
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
Removal and Installation
INFOID:0000000009176335
REMOVAL
CAUTION:
Bumper fascia is made of resin. Use care when handling to prevent damage. Avoid contact with oily
substances.
1. Open hood.
2. Remove the core support cover clips (A) and the core support
cover.
3. Partially remove the front fender protectors (LH/RH). Refer to
.
4. Remove the front grille. Refer to
EXT-23, "Removal and Installation"
NOTE:
Calibration must be performed after removing/replacing the camera. Refer to
CAMERA IMAGE (AROUND VIEW MONITOR) : Work Procedure"
5. Remove the front bumper fascia clips (A).
1.
Front bumper reinforcement
support (RH)
2.
Front bumper reinforcement
support (LH)
3.
Front bumper reinforcement
4.
Front energy absorber
5.
Front bumper side bracket
(RH)
6.
Front bumper side bracket (LH)
7.
Front bumper fascia
8.
Front license plate bracket
9.
Front air spoiler (upper)
10. Front camera (if equipped)
11. Front grille
12. Core support cover
13. Front fascia (side) molding
14. Tow cover
15. Front fascia finisher
16. Front fog lamp finisher (if
equipped)
17. Front air spoiler (lower
18. Front fascia (center) molding
ALKIA2902ZZ
ALKIA2899ZZ
EXT-18
< REMOVAL AND INSTALLATION >
FRONT BUMPER
6. Remove the front bumper fascia to fender screw (A) (LH/RH).
7. Disconnect the harness connectors from the fog lamps (LH/RH) (if equipped).
8. Release the front bumper fascia pawls from the side brackets
(LH/RH) as shown.
CAUTION:
When removing front bumper fascia, two people are
required to avoid damaging.
: Pawl
9. Remove the front bumper fascia.
10. Remove the following parts (if necessary) after removing front bumper fascia.
• Front air spoiler.
• Front fog lamp assemblies (LH/RH) (if equipped). Refer to
EXL-144, "Removal and Installation"
.
• Front license plate bracket. Refer to
11. Remove the front bumper fascia upper retainer bracket and remove front bumper fascia .
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
• The following table shows the specified values for checking normal installation status.
• Fitting adjustment cannot be performed.
Unit: mm (in)
ALKIA3030ZZ
AWKIA2130ZZ
ALKIA2960ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст