Nissan X-Trail 32. Manual — part 1243
FILLET MOLDING
EXT-31
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
FILLET MOLDING
Exploded View
INFOID:0000000010787447
Grommet
Screw grommet
Front fillet molding
Rear fillet molding
JMKIB3026ZZ
EXT-32
< REMOVAL AND INSTALLATION >
FILLET MOLDING
FRONT FILLET MOLDING
FRONT FILLET MOLDING : Removal and Installation
INFOID:0000000010787448
REMOVAL
1.
Remove front mudguard. Refer to
EXT-30, "FRONT MUDGUARD : Removal and Installation"
equipped)
2.
Remove front fillet molding fixing screws
and clip
.
3.
Remove front fillet molding fixing clips of front side according to
the numerical order 1
→
2 as shown in the figure.
4.
Apply protective tapes (A) on the part to protect it from damage.
5.
Remove front fillet molding fixing clips using a remover tool (A),
and then remove front fillet molding.
6.
Remove the following parts after removing front fillet molding.
: Clip
: Vehicle front
: Vehicle front
JMKIB2867ZZ
: Clip
JMKIB2868ZZ
: Vehicle front
JMKIB2869ZZ
: Clip
: Vehicle front
JMKIB2870ZZ
FILLET MOLDING
EXT-33
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
• Grommet.
• Screw grommet.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
• When installing front fillet molding, visually check the clips, then replace them with new parts if they
are damaged.
• When installing front fillet molding, check that clips are securely fitted in fender panel holes, and
then press them in.
REAR FILLET MOLDING
REAR FILLET MOLDING : Removal and Installation
INFOID:0000000010787449
REMOVAL
1.
Remove rear mudguard. Refer to
EXT-30, "REAR MUDGUARD : Removal and Installation"
. (if equipped)
2.
Remove rear fillet molding fixing screws
.
3.
Remove rear fillet molding fixing clips of rear side according to
the numerical order 1
→
2 as shown in the figure.
4.
Apply protective tapes (A) on the part to protect it from damage.
: Vehicle front
JMKIB2871ZZ
: Clip
JMKIB2872ZZ
: Vehicle front
JMKIB2873ZZ
EXT-34
< REMOVAL AND INSTALLATION >
FILLET MOLDING
5.
Remove rear fillet molding fixing clips using a remover tool (A),
and then remove rear fillet molding.
6.
Remove the following parts after removing rear fillet molding.
• Grommet.
• Screw grommet.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
• When installing rear fillet molding, visually check the clips, then replace them with new parts if they
are damaged.
• When installing rear fillet molding, check that clips are securely fitted in panel holes on body, and
then press them in.
: Vehicle front
JMKIB2874ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст