Nissan X-Trail 32. Manual — part 1633
PB-58
< BASIC INSPECTION >
CALIBRATION OF G SENSOR
4.
After approx. 10 seconds, touch “END”.
5.
Turn the ignition switch OFF and then turn it ON again.
CAUTION:
• Be sure to perform the operation above.
• Be sure to wait for 10 seconds or more after turning the ignition switch OFF or ON.
>> GO TO 3.
3.
PERFORM THE SELF-DIAGNOSIS
With CONSULT
1.
Pull parking brake switch to activate electric parking brake.
2.
Push parking brake switch to release electric parking brake.
3.
Perform “EHS/PKB” self-diagnosis.
Is malfunction detected?
YES
>> Check the DTC. Refer to
. GO TO 4.
NO
>> GO TO 4.
4.
CHECK DATA MONITOR
With CONSULT
1.
Drive the vehicle.
2.
Steer the steering wheel to the straight-ahead position.
3.
Stop the vehicle on level surface.
4.
Select “EHS/PKB”, “DATA MONITOR”, and “SLOPE RATIO” according to this order. Check that signals is
within the specified value. Refer to
Is the check result normal?
YES
>> GO TO 5.
NO
>> GO TO 1.
5.
ERASE SELF-DIAGNOSIS MEMORY
With CONSULT
1.
Turn the ignition switch OFF to ON.
CAUTION:
Be sure to wait for 10 seconds or more after turning the ignition switch OFF or ON.
2.
Erase self-diagnosis results memory of “EHS/PKB”.
Is the memory erased?
YES
>> INSPECTION END
NO
>> Check the items indicated by the self-diagnosis.
RESET OF CLUTCH STROKE SENSOR
PB-59
< BASIC INSPECTION >
C
D
E
G
H
I
J
K
L
M
A
B
PB
N
O
P
RESET OF CLUTCH STROKE SENSOR
Description
INFOID:0000000010722944
CAUTION:
When the following operations are performed, always use CONSULT, and carry “CLUTCH SENSOR
RESET” of “WORK SUPPORT”.
NOTE:
This work is M/T models.
×
: Required
—: not required
Work Procedure
INFOID:0000000010722945
CAUTION:
When the following operations are performed, always use CONSULT. (It cannot be performed by any
means other than CONSULT.)
• Replacing electric parking brake control module
• Removing/installing clutch stroke sensor
• Replacing clutch stroke sensor
• Removing/installing clutch pedal
• Replacing clutch pedal
NOTE:
This work is M/T models.
1.
CHECK THE VEHICLE STATUS
1.
Stop the vehicle.
2.
Stop the engine.
3.
Turn the ignition switch OFF.
>> GO TO 2.
2.
CHECKING INSTALLATION CONDITION OF CLUTCH COMPONENTS
Check the installation conditions of clutch components.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Repair or replace error-detected parts and GO TO 3.
3.
PERFORM CLUTCH SENSOR RESET
CAUTION:
Procedure
CLUTCH SENSOR RESET
Removing/installing electric parking brake control module
—
Replacing electric parking brake control module
×
Removing/installing rear brake pad (When not pressing piston of rear
brake caliper assembly)
—
Removing/installing rear brake pad (When pressing piston of rear brake
caliper assembly)
—
Replacing rear brake pad
—
Removing/installing rear brake caliper assembly
—
Replacing rear brake caliper assembly
—
Removing/installing parking brake switch
—
Replacing parking brake switch
—
Removing/installing clutch stroke sensor
×
Replacing clutch stroke sensor
×
Removing/installing clutch pedal
×
Replacing clutch pedal
×
PB-60
< BASIC INSPECTION >
RESET OF CLUTCH STROKE SENSOR
• Never allow passenger or load on the vehicle.
• Never apply vibration to the vehicle body when opening or closing door during calibration.
With CONSULT
1.
Turn the ignition switch ON.
CAUTION:
Never start the engine.
2.
Select “EHS/PKB”, “WORK SUPPORT”, and “CLUTCH SENSOR RESET” according to this order.
CAUTION:
Never depress the clutch pedal.
3.
Touch “START”.
>> GO TO 4.
4.
PERFORM THE SELF-DIAGNOSIS
With CONSULT
1.
Pull parking brake switch to activate electric parking brake.
2.
Drive the vehicle and check the automatic release.
3.
Perform “EHS/PKB” self-diagnosis.
Is malfunction detected?
YES
>> Check the DTC. Refer to
. GO TO 5.
NO
>> GO TO 5.
5.
CHECK DATA MONITOR
With CONSULT
Select “EHS/PKB”, “DATA MONITOR”, and “CLUTCH PEDAL” according to this order. Check that signals are
within the specified value. Refer to
.
Is the check result normal?
YES
>> GO TO 6.
NO
>> GO TO 1.
6.
ERASE SELF-DIAGNOSIS MEMORY
With CONSULT
1.
Turn the ignition switch OFF to ON.
CAUTION:
Be sure to wait for 10 seconds or more after turning the ignition switch OFF or ON.
2.
Erase self-diagnosis results memory of “EHS/PKB”.
Is the memory erased?
YES
>> INSPECTION END
NO
>> Check the items indicated by the self-diagnosis.
OPERATION OF REAR BRAKE CALIPER
PB-61
< BASIC INSPECTION >
C
D
E
G
H
I
J
K
L
M
A
B
PB
N
O
P
OPERATION OF REAR BRAKE CALIPER
Description
INFOID:0000000010722946
CAUTION:
When the following operations are performed, always use CONSULT, for performing “BRAKE OPERA-
TION” of “WORK SUPPORT”.
×
: Required
—: not required
*: M/T models
Work Procedure
INFOID:0000000010722947
CAUTION:
When the following operations are performed, always use CONSULT. (It cannot be performed by any
means other than CONSULT.)
• Removing/installing electric parking brake control module
• Replacing electric parking brake control module
• Removing/installing rear brake pad (When not pressing piston of rear brake caliper assembly)
• Removing/installing rear brake pad (When pressing piston of rear brake caliper assembly)
• Replacing rear brake pad
• Removing/installing rear brake caliper assembly
• Replacing rear brake caliper assembly
NOTE:
When the replaced rear brake pad, refer to
1.
PERFORM BRAKE OPERATION
With CONSULT
1.
Select “EHS/PKB”, “WORK SUPPORT”, and “BRAKE OPERATION” according to this order.
CAUTION:
• Never operate the parking brake switch.
• Never depress the brake pedal.
2.
Touch “START”.
>> GO TO 2.
2.
PERFORM BRAKE RELEASE
With CONSULT
1.
Select “EHS/PKB”, “WORK SUPPORT”, and “BRAKE RELEASE” according to this order.
CAUTION:
Procedure
BRAKE OPERATION
Removing/installing electric parking brake control module
×
Replacing electric parking brake control module
×
Removing/installing rear brake pad (When not pressing piston of rear
brake caliper assembly)
×
Removing/installing rear brake pad (When pressing piston of rear brake
caliper assembly)
×
Replacing rear brake pad
×
Removing/installing rear brake caliper assembly
×
Replacing rear brake caliper assembly
×
Removing/installing parking brake switch
—
Replacing parking brake switch
—
Removing/installing clutch stroke sensor
*
—
Replacing clutch stroke sensor
*
—
Removing/installing clutch pedal
*
—
Replacing clutch pedal
*
—
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст