Nissan X-Trail 32. Manual — part 1248
DOOR SASH TAPE
EXT-51
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
DOOR SASH TAPE
Exploded View
INFOID:0000000010787465
FRONT DOOR SASH TAPE
FRONT DOOR SASH TAPE : Removal and Installation
INFOID:0000000010787466
REMOVAL
CAUTION:
Never damage painted surface of front door panel.
1.
Remove front door sash molding. Refer to
EXT-49, "FRONT DOOR SASH MOLDING : Removal and
.
2.
Heat front door sash tape surface using a dryer, and then peel front door sash tape.
INSTALLATION
NOTE:
Refer to the figure for front door sash tape position and overlap distance between the front door sash tape.
Front door sash tape
Rear door sash tape front
Rear door sash tape rear
: Vehicle front
: Always replace after every disassembly.
JMKIB3000ZZ
EXT-52
< REMOVAL AND INSTALLATION >
DOOR SASH TAPE
CAUTION:
• Degrease front door panel mounting surface for front door sash tape.
• Paint grain or dust on mounting surface of front door sash tape may spoil exterior appearance if it
remains. Clean the mounting surface and check that no paint grain or dust remains, before starting
the operation.
• Never reuse front door sash tape.
1.
Affix front door sash tape
to front door panel
by applying pressure using a squeegee (A) while peel-
ing off release coated paper
.
NOTE:
• Peel release coated paper at distance of 10 – 20 mm (0.394 – 0.787 in) ahead (B) of squeegee and affix
front door sash tape.
• To prevent any bubbles from forming, slightly lift the portion, not yet affixed using squeegee, so that por-
tion dose not contact with panel surface.
• Apply pressure and affix at a low and constant speed using squeegee tilted at 40 – 50
°
angle (pushing
direction) (C) or 30 – 45
°
angle (pulling direction) (D).
Front door panel
Front door sash tape
R end
: Vehicle front
B 3.5 mm (0.138 in)
C 3.5 mm (0.138 in)
JMKIB3001ZZ
JMKIB1013GB
DOOR SASH TAPE
EXT-53
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
2.
For small radius portion of hemming part, gradually apply pres-
sure and affix front door sash tape
using squeegee (A) in
1
→
3 steps.
CAUTION:
Never wash the vehicle with in 24 hours so as to keep adhe-
sive.
REAR DOOR SASH TAPE
REAR DOOR SASH TAPE : Removal and Installation
INFOID:0000000010787467
REMOVAL
CAUTION:
Never damage painted surface of rear door panel.
1.
Remove rear door glass. Refer to
GW-51, "REAR DOOR GLASS : Removal and Installation"
.
2.
Remove rear door sash molding. Refer to
EXT-50, "REAR DOOR SASH MOLDING : Removal and Instal-
.
3.
Remove rear door outside molding. Refer to
EXT-56, "REAR DOOR OUTSIDE MOLDING : Removal and
.
4.
Heat rear door sash tape surface using a dryer, and then peel rear door sash tape.
INSTALLATION
NOTE:
Refer to the figure for rear door sash tape position and overlap distance the rear door sash tape.
JMKIB1014ZZ
Rear door panel
Rear door sash tape front
Rear door sash tape rear
JMKIB3002ZZ
EXT-54
< REMOVAL AND INSTALLATION >
DOOR SASH TAPE
CAUTION:
• Degrease rear door panel mounting surface for rear door sash tape.
• Paint grain or dust on mounting surface of rear door sash tape may spoil exterior appearance if it
remains. Clean the mounting surface and check that no paint grain or dust remains, before starting
the operation.
• Never reuse rear door sash tape.
1.
Affix rear door sash tape
to rear door panel
by applying pressure using a squeegee (A) while peeling
off release coated paper
.
NOTE:
• Peel release coated paper at distance of 10 – 20 mm (0.394 – 0.787 in) ahead (B) of squeegee and affix
rear door sash tape.
• To prevent any bubbles from forming, slightly lift the portion, not yet affixed using squeegee, so that por-
tion dose not contact with panel surface.
• Apply pressure and affix at a low and constant speed using squeegee tilted at 40 – 50
°
angle (pushing
direction) (C) or 30 – 45
°
angle (pulling direction) (D).
2.
For small radius portion of hemming part, gradually apply pres-
sure and affix rear door sash tape
using squeegee (A) in 1
→
3
steps.
CAUTION:
Never wash the vehicle with in 24 hours so as to keep adhe-
sive.
R end
: Vehicle front
C 3.0 mm (0.118 in)
D 3.5 mm (0.138 in)
E 3.5 mm (0.138 in)
F 3.0 mm (0.118 in)
JMKIB1013GB
JMKIB1014ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст