Nissan X-Trail 32. Manual — part 2020
TM-38
< REMOVAL AND INSTALLATION >
[6MT: RS6F94R]
DIFFERENTIAL SIDE OIL SEAL
DIFFERENTIAL SIDE OIL SEAL
Exploded View
INFOID:0000000010842454
Removal and Installation
INFOID:0000000010842455
REMOVAL
1.
Remove front drive shafts. Refer to
FAX-36, "MR20DD : Removal and Installation"
2.
Remove differential side oil seals
from clutch housing and
transaxle case, using oil seal remover (commercial service tool).
CAUTION:
Never damage transaxle case and clutch housing.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Install differential side oil seals
to clutch housing and transaxle
case, using the drift (Stamping number: B.vi 1666-B) of the drift set
(SST: KV32500QAA).
CAUTION:
• Never incline differential side oil seal.
Differential side oil seal
Transaxle assembly
: Vehicle front
: Always replace after every disassembly.
JSDIA5666ZZ
SCIA7625E
: Transaxle case side
: Clutch housing side
Dimension (L
1
)
: 1.2 – 1.8 mm (0.047 – 0.071 in)
Dimension (L
2
)
: 2.7 – 3.3 mm (0.106 – 0.130 in)
JPDIC0454ZZ
DIFFERENTIAL SIDE OIL SEAL
TM-39
< REMOVAL AND INSTALLATION >
[6MT: RS6F94R]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
• Never damage clutch housing and transaxle case.
• Perform inspection after installation. Refer to
.
Inspection
INFOID:0000000010842456
INSPECTION AFTER INSTALLATION
Check the oil level and oil leakage. Refer to
.
TM-40
< REMOVAL AND INSTALLATION >
[6MT: RS6F94R]
AIR BREATHER
AIR BREATHER
Exploded View
INFOID:0000000010842457
Removal and Installation
INFOID:0000000010842458
REMOVAL
1.
Remove battery and battery trays. Refer to
PG-148, "EXCEPT FOR R9M : Removal and Installation"
.
2.
Remove air breather hose from transaxle assembly.
3.
Remove air breather cap from air breather hose.
INSTALLATION
Note the following, and install in the reverse order of removal.
• When inserting air breather cap
to air breather hose
, be sure
to insert the hose until end of the cap.
• Install air breather hose
so that the paint mark
is faced for-
ward of the vehicle as shown in the figure.
• When inserting air breather hose to transaxle assembly, be sure to
insert it fully until its end reaches the stop.
• When installing air breather hose, make sure there are no pinched
or restricted areas on air breather hose caused by bending or
winding.
Air breather cap
Air breather hose
Transaxle assembly
: Vehicle front
JSDIA5667ZZ
JSDIA5801ZZ
: Vehicle front
JSDIA5798ZZ
TRANSAXLE ASSEMBLY
TM-41
< UNIT REMOVAL AND INSTALLATION >
[6MT: RS6F94R]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
UNIT REMOVAL AND INSTALLATION
TRANSAXLE ASSEMBLY
Exploded View
INFOID:0000000010842459
Removal and Installation
INFOID:0000000010842460
CAUTION:
Never reuse CSC (Concentric Slave Cylinder). Because CSC slides back to the original position every
time when removing transaxle assembly. At this timing, dust on the sliding parts may damage a seal of
CSC and may cause clutch fluid leakage. Refer to
CL-30, "Removal and Installation"
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spill-
ing.
REMOVAL
1.
Shift the shift lever to the neutral position.
2.
Remove engine assembly together with transaxle assembly from vehicle. Refer to
.
3.
Remove air breather hose. Refer to
TM-40, "Removal and Installation"
.
4.
Remove starter motor. Refer to
STR-27, "MR20DD : Removal and Installation"
5.
Remove clutch tube from CSC (Concentric Slave Cylinder). Refer to
CL-27, "Removal and Installation"
CAUTION:
Keep painted surface on the body or other parts free of clutch fluid. If it spills, wipe up immediately
and wash the affected area with water.
6.
Remove the bolts that fasten the transaxle assembly and engine assembly.
7.
Remove transaxle assembly from the engine assembly.
8.
Remove engine mounting bracket (LH). Refer to
EM-56, "Removal and Installation"
.
9.
Remove CSC. Refer to
CL-30, "Removal and Installation"
.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
• The transaxle assembly must not interfere with the wire harnesses and clutch tube.
Transaxle assembly
: N·m (kg-m, ft-lb)
JSDIA5822GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст