Nissan X-Trail 32. Manual — part 1102
AIR CLEANER FILTER
EM-305
< PERIODIC MAINTENANCE >
[R9M]
C
D
E
F
G
H
I
J
K
L
M
A
EM
N
P
O
MAINTENANCE INTERVAL
Inspection (Viscous Paper Type)
INFOID:0000000011004808
INSPECTION AFTER REMOVAL
Examine with eyes that there is no stain, clogging, or damage on air cleaner element.
• Remove dusts (such as dead leafs) on air cleaner element surface and inside cleaner case.
• If clogging or damage is observed, replace the air cleaner element.
CAUTION:
Never clean the viscous paper type air cleaner element by blowing as there is a risk of deterioration of
its performance
MAINTENANCE INTERVAL
EM-306
< REMOVAL AND INSTALLATION >
[R9M]
ENGINE COVER
REMOVAL AND INSTALLATION
ENGINE COVER
Exploded View
INFOID:0000000011004823
Removal and Installation
INFOID:0000000011004824
REMOVAL
1.
Remove Oil filter cap.
2.
Move harness.
3.
Remove engine cover.
CAUTION:
• Never damage or scratch engine cover when installing or removing.
INSTALLATION
Install in the reverse order of removal.
Engine cover
Oil filler cap
: N·m (kg-m, in-lb)
JPBIA6949GB
DRIVE BELT AUTO TENSIONER AND IDLER PULLEY
EM-307
< REMOVAL AND INSTALLATION >
[R9M]
C
D
E
F
G
H
I
J
K
L
M
A
EM
N
P
O
DRIVE BELT AUTO TENSIONER AND IDLER PULLEY
Exploded View
INFOID:0000000010784309
Removal and Installation
INFOID:0000000010784310
CAUTION:
• Replace the drive belt that has been removed with a new one.
• Drive belt auto-tensioner and idler pulley must be replaced with new ones when the drive belt is
replaced.
• Never run the engine without the drive belt to avoid damaging the crankshaft pulley.
REMOVAL
1.
Remove drive belt. Refer to
EM-300, "Removal and Installation"
• Keep drive belt auto-tensioner pulley arm locked after drive belt is removed.
2.
Remove drive belt auto-tensioner.
3.
Remove rear torque rod mounting bolt.
4.
Move engine, and remove cover and idler pulley.
INSTALLATION
Install in the reverse order of removal.
Drive belt auto-tensioner
Cover
Idler pulley
: Vehicle front
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.
JPBIA6944GB
EM-308
< REMOVAL AND INSTALLATION >
[R9M]
AIR CLEANER AND AIR DUCT
AIR CLEANER AND AIR DUCT
Exploded View
INFOID:0000000010784311
Removal and Installation
INFOID:0000000010784312
REMOVAL
NOTE:
Mass air flow sensor is removable under the car-mounted condition.
1.
Remove air duct 1 and air duct 2.
• To remove air duct 2
, pinch pawl
to unlock, move pawl
frontward, and remove air duct 2 upward.
JPBIA6926GB
Air duct
Mass air flow sensor
Collar
Grommet
Air cleaner body
Mounting rubber
Bracket
Air cleaner filter
Air cleaner cover
Air duct 2
Air duct 1
To turbochager
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
: Vehicle front
JSBIA4626ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст