Nissan X-Trail 32. Manual — part 1777
COMPONENT PARTS
SB-7
< SYSTEM DESCRIPTION >
C
D
E
F
G
I
J
K
L
M
A
B
SB
N
O
P
Seat belt warning is displayed on information display for approxi-
mately 35 seconds when the following conditions.
• Ignition switch is ON and engine starts running.
• Rear seat belt buckle switch is turned ON (rear seat belt is not fas-
tened) and vehicle speed is 15 km/h (9.3 MPH) or more.
Seat belt warning is canceled when the following conditions.
• Ignition switch is turned OFF.
• Approximately 35 seconds are passed since rear seat belt warning
is displayed.
Seat belt warning chime
INFOID:0000000010927768
• Front seat belt warning chime sounds for approximately 90 seconds when the vehicle speed is approxi-
mately 15 km/h (9.3 MPH) or more while front seat belts are not fastened. Front seat belt warning chime
stops when front seat belt is fastened.
• Rear seat belt warning chime sounds for approximately 0.05 seconds after rear seat belt warning is dis-
played.When any of the rear seat belt buckle (LH,RH or center) is unfastened from the fastened status at a
vehicle speed of 15 km/h (9.3 MPH) or more, a chime integrated in the seat belt warning unit sounds for 0.05
seconds.
JMHIA2936ZZ
SB-8
< SYSTEM DESCRIPTION >
SYSTEM
SYSTEM
WARNING/INDICATOR/CHIME LIST
WARNING/INDICATOR/CHIME LIST : Warning Lamp/Indicator Lamp
INFOID:0000000010927769
WARNING/INDICATOR/CHIME LIST : Warning Chime
INFOID:0000000010927770
WARNING/INDICATOR/CHIME LIST : Warning Lamp/Indicator (Information Display)
INFOID:0000000010927771
Item
Design
Reference
Seat belt warning lamp
For layout, refer to
MWI-10, "METER SYSTEM : Design"
MWI-54, "WARNING LAMPS/INDICATOR LAMPS : Seat Belt
.
Rear seat belt warning lamp
For layout, refer to
SBC-8, "INFORMATION DISPLAY (COMBINATION METER) : Rear
SBC-7, "SEAT BELT WARNING LAMP CONTROL SYSTEM :
.
Item
Reference
Seat belt warning
Refer to
WCS-17, "WARNING CHIME : Seat Belt Warning"
Item
Reference
Rear seat belt warning
SBC-7, "SEAT BELT WARNING LAMP CONTROL SYSTEM : System Description"
FRONT SEAT BELT
SB-9
< REMOVAL AND INSTALLATION >
C
D
E
F
G
I
J
K
L
M
A
B
SB
N
O
P
REMOVAL AND INSTALLATION
FRONT SEAT BELT
Exploded View
INFOID:0000000010927772
JMHIA2928GB
SB-10
< REMOVAL AND INSTALLATION >
FRONT SEAT BELT
SEAT BELT RETRACTOR
SEAT BELT RETRACTOR : Removal and Installation
INFOID:0000000010927773
WARNING:
Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait for 3 minutes
or more (discharges electricity held in the additional power supply circuit of the air bag diagnosis sen-
sor unit).
CAUTION:
When removing, always use a remover tool that is made of plastic to prevent damage to the parts.
REMOVAL
1.
Remove shoulder anchor.
a.
Slide the front seat to front most position.
b.
Remove adjuster cover.
i.
Pull the adjuster cover
lower side, and then disengage the
adjuster cover lower side fixing pawls.
ii.
Apply protective tape (A) on the parts to protect it from damage.
Anchor bolt
Seat belt adjuster
Retaining washer
Spacer
Shoulder anchor
Adjuster cover
Seat belt pre-tensioner retractor as-
sembly (Driver side)
Seat belt buckle (Driver side)
Seat belt buckle (Passenger side)
Seat belt pre-tensioner retractor as-
sembly (Passenger side)
: Clip
: Pawl
: N·m (kg-m, ft-lb)
: Pawl
JMHIA2261ZZ
JMHIA2262ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст