Nissan X-Trail 32. Manual — part 1460
MAP LAMP
INL-77
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
INL
N
O
P
1.
Disengage map lamp assembly fixing pawls and metal clips
according to numerical order 1
→
2 indicated by arrows as shown
in the figure.
2.
Disconnect harness connectors, and then remove map lamp assembly.
INSTALLATION
Install in the reverse order of removal.
MAP LAMP : Replacement
INFOID:0000000010755163
MAP LAMP BULB
CAUTION:
Replacement of a single part is not possible due to the adoption of LED. For replacement, replace map
lamp assembly as a set.
MAP LAMP BRACKET
MAP LAMP BRACKET : Removal and Installation
INFOID:0000000010755164
REMOVAL
1.
Remove all assist grips.
Disengage assist grip cap fixing pawl using a remover tool (A),
and then slide assist grip cap and remove it according to numer-
ical order 1
→
2 indicated by arrows as shown in the figure.
2.
Disengage assist grip fixing metal clips, and then remove assist grip.
3.
Remove center pillar upper garnish (LH and RH). Refer to
INT-28, "CENTER PILLAR UPPER GARNISH :
.
4.
Remove front pillar garnish (LH and RH). Refer to
INT-23, "FRONT PILLAR GARNISH : Removal and
.
5.
Remove light & rain sensor cover. Refer to
WW-109, "Removal and Installation"
. (With light & rain sensor)
6.
Remove map lamp assembly. Refer to
INL-76, "MAP LAMP : Removal and Installation"
.
7.
Remove sun visor assembly (LH and RH).
: Pawl
: Metal clip
JMLIA4261ZZ
: Pawl
JMJIA8937ZZ
INL-78
< REMOVAL AND INSTALLATION >
MAP LAMP
a.
Disengage sun visor cover fixing pawls using a remover tool (A),
and then remove sun visor cover (LH and RH).
b.
Remove sun visor assembly fixing screws, and then disconnect vanity mirror lamp harness connector.
(With vanity mirror lamp)
c.
Remove sun visor assembly (LH and RH).
8.
Remove sun visor holder (LH and RH) using a remover tool (A)
according to numerical order 1
→
2 indicated by arrows as shown
in the figure.
9.
Disengage dual lock fasteners
between headlining assembly
and roof panel. (With sunroof)
CAUTION:
Never bend headlining when removing.
10. Remove front portion of headlining assembly from roof panel.
CAUTION:
To prevent damage of the headlining assembly, hold it
using a rope (A) or belt.
: Pawl
JMJIA4399ZZ
JMJIA9251ZZ
JMJIA9639ZZ
JMKIB2588ZZ
MAP LAMP
INL-79
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
INL
N
O
P
11. Disengage map lamp bracket fixing dual lock fastener
from
roof panel. (With sunroof)
12. Remove map lamp bracket fixing clips
. (Without sunroof)
13. Disengage map lamp bracket fixing metal clips.
14. Remove map lamp bracket from between headlining assembly
and roof panel.
CAUTION:
Never damage windshield glass.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
• Make sure that map lamp bracket fixing dual lock fastener are engaged to roof panel. (With sunroof)
• Visually check clips for deformation and damage during installation. Replace with new ones if neces-
sary. (Without sunroof)
• Visually check metal clips for deformation and damage during installation. Replace with new ones if
necessary.
: Vehicle front
JMLIA4263ZZ
JMLIA5106ZZ
: Metal clip
JMLIA5107ZZ
JMLIA5108ZZ
INL-80
< REMOVAL AND INSTALLATION >
VANITY MIRROR LAMP
VANITY MIRROR LAMP
Exploded View
INFOID:0000000010755165
Replacement
INFOID:0000000010755166
VANITY MIRROR LAMP BULB
CAUTION:
• Disconnect the battery negative terminal or remove power circuit fuse when performing the opera-
tion for preventing electric leakage. Refer to
INL-4, "Precautions for Removing Battery Terminal"
• Never touch the glass surface of the bulb with bare hands or allow oil or grease to get on it for pre-
venting damage to the bulb.
• The surface of the bulb is very hot just after the lamp is turned OFF. Never touch the glass surface of
the bulb with bare hands for preventing burns.
• Leaving the bulb removed from housing for a long period of time can deteriorate performance of the
lens and reflector (due to dirt or clouding). Always prepare a new bulb and have it on hand when
replacing the bulb.
1.
Apply protective tapes (A) to vanity mirror of surface for protect-
ing it from damage.
Lens
Bulb
: Pawl
JMLIA0540ZZ
JMLIA4268ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст