Nissan Terrano r20e. Manual — part 84
BACK DOOR WINDOW
I
Window glass is held in place by weatherstrip. Refer to
“EXTERIOR”, BT-21.
I
Apply sealer to clearances between vehicle body panel and
weatherstrip as necessary.
EBF030
WINDSHIELD AND WINDOWS
Removal and Installation (Cont’d)
BT-47
Removal and Installation
CAUTION:
Be careful not to scratch door rearview mirror body.
★
For Wiring Diagram, refer to EL-241, “DOOR MIRROR” for details.
1. Remove door trim. Refer to “DOOR TRIM”, BT-19.
2. Remove inner cover front corner of door.
3. Disconnect door mirror harness connector.
4. Remove harness clips.
5. Remove bolts securing door mirror assembly.
EBF031
DOOR MIRROR
BT-48
Alignment
I
All dimensions indicated in figures are actual ones.
I
When using a tracking gauge, adjust both pointers to equal length. Then check the pointers and gauge
itself to make sure there is no free play.
I
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
I
Measurements should be taken at the center of the mounting holes.
I
An asterisk (*) following the value at the measuring point indicates that the measuring point on the other
side is symmetrically the same value.
I
The coordinates of the measurement points are the distances measured from the standard line of “X”, “Y”
and “Z”.
YBT089
BODY (ALIGNMENT)
BT-49
ENGINE COMPARTMENT
Measurement
Unit: mm (in)
NBF021
BODY (ALIGNMENT)
Alignment (Cont’d)
BT-50
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст