Nissan Terrano r20e. Manual — part 404
I
Remove bearing lock nut with Tool.
I
Remove rear axle shaft using special tool.
I
Remove grease seal in bearing cage with suitable bar.
I
Remove wheel bearing outer race.
Suitable tool is included in Rear Axle Removal/Installation kit
NI-104.
Inspection
AXLE SHAFT
I
Check axle shaft for straightness, cracks, damage, wear or
distortion. Replace if necessary.
BEARING HOUSING
I
Check bearing housing for deformation or cracks. Replace if
necessary.
REAR AXLE HOUSING
I
Check rear axle housing for yield, deformation or cracks.
Replace if necessary.
YRA005
NRA023
SRA015
SRA287A
REAR AXLE
Removal (Cont’d)
RA-8
Installation
I
Press new wheel bearing until it touches the bottom of the
bearing housing.
Always press outer race of wheel bearing during installation.
I
Press new grease seal until it bottoms end face of bearing
housing.
After installing new grease seal, coat sealing lip with multipur-
pose grease.
I
Install baffle plate over bearing housing and press axle shaft
into inner race of wheel bearing.
Be careful not to damage or deform grease seal.
I
Install washer and lock washer.
I
Before installing lock nut, apply a coat of wheel bearing grease
to its seat. Tighten lock nut to specified torque.
: 245 - 249 N
⋅
m
(25 - 30 kg-m, 181 - 217 ft-lb)
I
Turn bearing housing (with respect to axle shaft) two or three
times. It must turn smoothly.
SRA288A
SRA289A
SRA290A
YRA005
ERA016
REAR AXLE
RA-9
I
Secure lock nut by bending one portion of lock washer.
Installation
Install the sensor rotor using suitable drift and press.
I
Always replace sensor rotor with new one.
I
Pay attention to the direction of front sensor rotor as shown in
figure.
I
Install new oil seal to rear axle housing using a suitable tool.
After installing new oil seal, coat sealing lip with multi-purpose
grease.
I
Position axle shafts in rear axle housing.
Be careful not to damage oil seal.
I
When the ball-bearing holder and the brake are installed in the
base of the axle, they need to be correctly positioned.
A quick way to determine on which side the holder should be
located, is to look at the brake adjustment screw.
Left-hand thread:
Install the holder on the left side.
Right-hand thread (Normal)
Install the holder on the right side.
SRA104
SBR402D
SRA292A
ERA017
REAR AXLE
Installation (Cont’d)
RA-10
I
Insert axle shaft with Tool as a guide.
When inserting axle shaft, be careful not to damage oil seal.
I
Tighten nuts to the specified torque.
: 53 - 63 N
⋅
m (5.4 - 6.4 kg-m, 39 - 46 ft-lb)
I
Install ABS-sensor.
I
Measure end play of axle shaft.
Axial end play:
0.0 mm (0.0000 in)
YRA006
ERA013
YRA003
REAR AXLE
Installation (Cont’d)
RA-11
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст